Top 20 Nortel IP Phone 2004 NTDU92BD70E6 Questions & Answers


Forward No Answer is not working or voice mail is down.
Call your office administrator or local tech to check programming on the phone system.

Nortel IP Phone... | 130 views | 0 helpful votes


Answer> Manuals: If you want FREE manuals for your device, you must go directly to the maker of your hardware device. Look for their SUPPORT (Drivers and Downloads) and input the required data such as the Make, Mod. of the device in question. They will then take you to the proper section where Drivers and Manuals are located. Here you simply select the option you want to download and install your drivers or open a manual. Manuals often come down in PDF format and require Adobe Reader. Get Reader form http://www.Adobe.com .

Nortel Radio... | 143 views | 0 helpful votes


Connect the headset to the charger as if you were charging it, but keep one side in your ear. Once connected to the charger, hold down the power button. It'll beep a few times and then stop. Disconnect from the charger. You can then turn the headset back on. This "procedure" clears the headset's memory,

Radio... | 37 views | 0 helpful votes


It sound like your power supply is not providing enough output for the radio. Are you by chance using a wall wart for power? You need a dedicated 12 volt power supply, made by Astron, QJE, or Pyramid.

Radio... | 93 views | 0 helpful votes


try to do a Hard reset on the unit and then reload your freq list from Chirp. It happened to my UV-5R-v2 Baofeng. It worked fine after that.

Radio... | 35 views | 0 helpful votes


you may have a bad squelch pot on the radio. try turning it fully in one direction an back in the other direction. it also could be that the Pot is dirty get some contact cleaner and open up the radio and squirt a very little cleaner into the open spot of the Pot. then rotate the know several times. if you do not have something like CRC QD Contact Cleaner you can get it in a good hardwood store like ACE or TrueValue, and even Home Depot. you can use only 91-99% Electronic Grade Isopropyl Alcohol, do not use the 70% Isopropyl Alcohol.

Radio... | 29 views | 0 helpful votes


Your Baofeng radio may be able to scan for them.

Radio... | 34 views | 0 helpful votes


The usual cause is that the transmit button on the mike is broken or stuck in the "talk" position. If you disconnect the mike and the radio, then turn the radio on and it still is showing transmit, then the issue is inside the radio or the connector for the mike.
If the radio stays in receive mode with the mike disconnected, look at the mike connector for any bent pins or damage to the connector. If you don't see anything, try spraying electronic contact cleaner , the could be some corrosion that is causing a short here. Another thing, if you have it, is to use a different mike and see if that works properly.

Radio... | 38 views | 0 helpful votes


The overall reports on this radio, which appears to have been discontinued, is that it has a number of problems and needs to be serviced and the circuits aligned by someone with the appropriate skills and equipment. If you purchased it recently, from all reports, see if you can get it serviced under warranty.
otherwise, find a good CB repair shop and have them check it. The likely culprit is a bad transmit circuit. Not a easy fix unless you have the tools to test properly.

Radio... | 29 views | 0 helpful votes


Most headsets do not have a reset since there is nothing to reset. If you need to pair it again with a phone, go into the settings of the phone, find the bluetooth device list and tell the phone to forget the headset. then do the pairing again, after fully charging the headset.

Radio... | 29 views | 0 helpful votes


go to cellphones. This is radio communications

Radio... | 47 views | 0 helpful votes


If the radio is designed to use a two prong connector, then you will need to replace it with the same type. Generally, one prong is for the mic and the other is the speaker. There is usually a common ground on one of them and possibly the push to talk on the mic prong.
You shouldn't have much trouble finding a two prong replacement mic, eBay has many for most radios.

Radio... | 24 views | 0 helpful votes


Here's a guess. Pull the fuse for the radio and replace. If you can't find a fuse, remove the battery cable, and replace. Good luck.

Radio... | 45 views | 0 helpful votes


PERHAPS THE RESET BUTTON IS STUCK IN

Radio... | 31 views | 0 helpful votes


Your antenna should not make any difference with power or receiving. Is the scanner mobile or in a room? Hard to imagine the connector being broken. You could test the antenna or even the BNC connector on the scanner. Try another antenna. If you wiggle it, does it start receiving? You may have a short in the BNC to the receiver. Other than that, look to power issues.

Radio... | 45 views | 0 helpful votes


Radio frequencies are different from country to country. NZ will use different frequencies than Canada. Canada and the USA have agreements in place because they border each other on what freq. is used for what. NZ likely has its own list. Your radio is not programmable to NZ frequencies. Sorry!

Radio... | 36 views | 0 helpful votes


What type of radio are you talking about Ham Radio, AM & FM Radio? we need more information then this:

"Electricity went out. Unable to get radio channel of my choosing"

Radio... | 25 views | 0 helpful votes

Not finding what you are looking for?
Nortel IP Phone 2004 NTDU92BD70E6 Logo

3 questions posted

Ask a Question

Usually answered in minutes!

Top Nortel Radio Communications Experts

Norm Pearl

Level 2 Expert

108 Answers

MrFixitSTTL

Level 3 Expert

320 Answers

ray gallant
ray gallant

Level 3 Expert

64309 Answers

Are you a Nortel Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Nortel Radio Communications

  • Nortel Radio Communications

Most Popular Question

ringing only no voicemail nortel

  • Radio Communications
Loading...