20 Most Recent Uniden DECT1560 DECT 6.0 Expandable Cordless Phone System with Caller ID, DECT-1560,DECT 1560 - Page 9 Questions & Answers

online at uniden ---or manual search -uniden bctx15- Easier to Read BCT15 Scanner Manual

Try pulling the power plug, or adjusting the squelch.

The coax jumpers between the meter and the radio can change the SWR a little bit. It is very unlikely the the antenna can be that low on 1 and 40. Set it for the lowest on 20 via the radio and as long as you are under a 2 on 1 and 40 then it should be OK.

just speak no hum

? model

check uniden site they very reasonable repair Check yahoo groups for this model

? that is correct range unless u want ils ect

good ? we are using funny codes and no one is telling what they are.

Swap the speakers from one unit to the other, if it works then the WT is defective.

check google search

How do you know that the radio does not transmit? The batteries need to be fully charged, or new to transmit. The radio is old, and the cost to repair it may be close to how much a new CB radio is. Good luck.

104 Here's a wiring diagram

Make certain you are charging with the radio OFF. If on, the radio will use a small amount of energy and the charger will not know the battery is fully charged. If you intend to leave it on the charger, ON as in standby, then the lights will always flash. I would put a timer on the wall adapter so the battery is not always being charged. A battery always being charged will not last long, likely get hot and may cause problems. These are light duty radios, not designed for 24 hour if even daily use.

The simplest way is to order a microphone adapter from ebay or a reputable CB shop. I have all my mics wired for standard 4 pin cobra. The standard 4 pin cobra is the most common and if you keep adapters handy then you can use all different kinds of mics on different radios.

Here is a link to the user manual. https://www.uniden.com.au/RESOURCES_MAIN/pdfs/UH_8060S_OM.pdf