20 Most Recent
Kenwood Kpg-35 V2.00 Programming Software Tk-480 Tk-481 - Page 6 Questions & Answers
How do i get my tk -760 hg to scan the channels
Your microphone must be grounded properly. The mic hang up clip must be grounded. Then, if the programer enabled scan, you press the scan button. Lots of features in the Dealer programming that can affect scan, including priority, talk back and hang time.
My kenwood ts 700sp display stopped working. It don't change when I rotate the dial. Was working fine now it just stays on 144.000
Where should I look?
I had this happen on a Kenwood and this may be what has happened to you. Take your top and bottom covers off and then you will need to undo the front panel from the chassis so you can tilt it to be able to get to the main dial VFO encoder. You will need to remove the main tuning knob and then remove the encoder and take it apart. What happened in mine was the main encoding wheel which is a very thin round wheel with tons of small slots that break a light beam causing the frequency to change. My encoding wheel glue let the disk come off. The shaft turned but not the encoding wheel itself. Check this first. If you have a scope you could check to output pulse train of the encoder before taking it apart. No pulse train from the encoder could mean the disk encoder wheel is not moving. Good luck. Dennis
Flashing red light charger
This usually means an open circuit. That means a short. Your battery is very likely bad (99%). Slight possibility of a bad charger. Make certain you have the correct wall adapter.
Not finding what you are looking for?