20 Most Recent Connex CX-3400hp AM/FM 10 Meter Amateur Mobile Transceiver - Page 4 Questions & Answers

could be in your finalwhere the problem exists.Try flexing your board by pushing down in the center to see if any noise comes through.

18 ft. you shouldn't have to worry because a 102 is carring a good match anyway.Make sure you use the good stuff and its not the skinny coax.

did you check to see if it was still plugged in.maybe the reverse polarity diode or a crack in the pcb

hows the SWR ?the ground? the antenna itself? on the inside check the final.

cbtricks.com

don't use the amp you are drawing to much power for it and thats why the cord is getting hot.

http://www.cbradio.nl/connex/Connex.htm

Where are you located and what is the problem?

That's mod needs to be done by a radio shop. Try to find a decent on. Not just any cb shop. They shouldn't charge any more than $25 for that mod. We are in TX.

mic may be wired wrong, be wrong impedance for this radio

Check power leads inside of radio, "usually red and black" right off the leads there should be a black diode "shorts" if wires have been hooked up backwards, also check for an open foil on the printed circuit board.

If no power, check the red and black wires inside the radio, there should be a black diode right is near the leads often shorts if wires are hooked up backwards, also look for an open foil on the printed circuit board.