20 Most Recent
Ricoh CL4000DN Laser Printer - Page 2 Questions & Answers
Polygon mirror motor
Polygonal motor is inside the laser unit. You need a technician to repair this.
RICOH SPC430DN
error sc202
sc202 is a polygon mirror motor. The most likely problem is that the motor has gone bad, and it will need to be replaced. Occasionally this error is caused by a loose or disconnected cable, but it is usually a bad mirror motor. You should contact your local service technician for replacement of the polygon mirror motor.
Code error 307
sc 307 is a charge bias error having to do with the yellow photoconductor unit (PCU). Replacing the yellow PCU should resolve your problem. If the problem persists even with a new PCU, you will likely need to have either the high voltage supply board or the drum positioning plate replaced.
Thanks for using FixYa!
I have a CL4000DN making
it is possible that the drive gear in the fuser has failed. this will cause a very loud grinding sound in the back of the unit where the paper comes out. you can order new gears for it but sometimes its easier to replace the Fuser.in saying all this where is the noise coming from?
Ricoh CL4000DN. I recharged the magenta toner
Hi, the chip on those toner bottles stores information about how much toner is left, so once that chip registers an empty toner bottle, it won't work even if you attach it to a new toner bottle. You'll need the chip from a new toner bottle, or one that hasn't registered no toner.
I get an SC242 error
Hi
Thanks
for using FixYa. I think the error is sc542 not sc242 as there is no such error
for Ricoh. If it is sc542 then it is a fuser warm up error, to resolve this
please follow these steps:
- To start with Press and hold online + escape, then power on.
- Use up and down arrow keys to select SP2
- Press Enter
- Use
up and down arrow to locate SP5
- Press
Enter
- Use
up and down arrow keys to select 810
- Press
Enter
- Confirm
the selection
- Turn it off and on.
Please do accept the solution if the issue is
resolved or post a comment for further assistance.
Thanks
Rylee
Ricoh cl4000dn toner bottle sensor
The toner bottle sensors don't go bad too often. Do you have an extra yellow toner bottle? Try replacing that first. Compare the tray where the yellow toner bottle sits to the other three colors, and make sure nothing where the toner bottle connects is broken or bent.
Not finding what you are looking for?