20 Most Recent Precor Efx 5.17 - Page 5 Questions & Answers

is the safety key inserted as there may be a connection to not allow the unit to operate unless the key is in position

If you wish to get some details about treadmill repair ; check the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

If you wiah to get some details about treadmill repair and service then check the following link http://electro-medical.blogspot.com/

https://www.youtube.com/watch?v=aS1vwToqa1Y If you wish to get some details; check the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

If you wish to get some details a bout treadmill repair then check the link bellow. http://electro-medical.blogspot.com/

http://electro-medical.blogspot.com/. Visit this site to get more details.

Hi Emily, The safety switch... If that's the plastic part with the steel plate inside it that attaches to the console and when you remove it the treadmill won't operate then try cutting the top off a can and using that until you find the safety switch...Good Luck.....CHEERS..

Starting at the outlet, follow power into the machine. If you are getting power past the circuit breaker and in to the power board, chances are your lower board is toast. The only solution is to replace the item with a new or known good used board. The following links will take you to a video on how to use a multimeter to verify power. Video about Multimeter Testing

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH The following link will take you to some information on this model. Precor Equipment Repair Parts Treadmill Belts Ramp Sleeves SPORTSMITH net

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH This sounds like you are dealing with a worn deck and belt. If you apply wax periodically, you can prolong the life of these components. Using your serial number, the link below will help you find the deck and belt needed for your model. Precor Repair Parts for 9 45 9 45i Treadmills Consumer SPORTSMITH net

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Precor Error LS, Speed Sensor Signal Missing Probable Cause 1. Intermittent or open connection of the speed sensor (reed switch) wiring. 2. Reed switch is defective or has intermittent connection. 3. Drive motor brushes are bad. 4. Lower PCA is bad. Corrective Action

1. Inspect the speed sensor (reed switch) wiring for damage or poor connection to the lower PCA. Replace damaged wiring or reset connection as necessary.
2. Using an ohm meter, test the reed switch while rotating the drive pulley. The reed switch will close when the magnet passes in front of it.
3. Inspect the drive motor brushes and replace if necessary.
4. Test unit with a known good lower PCA. Replace lower PCA if necessary.

Precor Error Code LS

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH This sounds like you are dealing with a bad upper display board.

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH You can find the diagram for this model by using your model and serial number at the following link. Repair Parts for Precor C954i Treadmills 120VAC 240VAC SPORTSMITH net

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH The max user weight is 350 lbs.

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Typically this is caused by a bad pillow block bearing. I would suggest trying to pin point the sound a bit better, but this is common of the pillow block bearings. Precor Parts for EFX 554i 556 556i Ellipticals SPORTSMITH net

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH You should start by inspecting the brushes inside the motor. If these are worn, which is common over time, then the motor would start to lose power. The following link will take you to a motor brush. Be sure and have your complete model and serial number available to confirm the brush is compatible. Motor Brush Pac Sci YP00521 Each Precor PPP000000020002112 SPORTSMITH net