This indicatin is problem with the speed sensor, see the diagram attached, test the s. sensor for open or faulty. clean it, and tigh the plug or connector very well.Try to run The software calibration for easy diagnose,troubleshooting, and fix it. God bless you
adjust the speed sensor , see the diagram, clean it , and tight the plug or connector very well, and test it and replace if necessary2) measure the input voltage for motor, if there are the motor need repair, see my personal TIPS3) test the output voltage board, for input voltage motor, if there are NOT the board is faulty, see the b. diagram attached..God bless you
RUN the software calibration for diagnostic, troubleshooting and fix it.2) LUBE THE deck belt3) LUBE the rollers bearing4) adjust the speed sensor see the diagram, clean it, and tight the plug 5) adjust the REED swtich see the diagram, clean it, and tight the plug.6) see the block d. God bless you
LUBE the deck belt,this happens because the lack of maintenance2) LUBE the rollers bearing too, very important.3) adjust the speed sensor see the diagram attached, clean it, and tight the plug.4) adjus the REED swtich, see the diagram clean it, and plug the connect very well.5) Try after you did the adjustment RUN the software calibration for diagnostic, troubleshooting, and fix it. God bless you
the best way is read you instruction manual, for instruction about this notification.2) You must Lube the deck belt, by lack of maintenance you can have this notification. 3) Lube the rollers bearing.4) Download the instruction manual if you do not have www. fitness.manualsonline.com or www. iconservice.com5) Run the software calibration for diagnose and troubleshooting.God bless you
Typically a non start up of any electrical Exercise equipment raises alot of red flags If this treadmill will not start Check the internal fuse MAKE SURE ITS NOT PLUGGED IN!!!! UNPLUG IT FROM THE WALL2 If there is NO Fuse and you just bought it new Return it for an exchange.3 Check your wall outlet for less then 5 Bucks you can buy a wall outlet tester that tells you if your Outlet is good Or Bad.4 DO NOT Attempt to service this item on your own the way they make treadmills you have to have a qualified service tech come out and fix it because the risk of serious shock or death is emminent.
