This is not sounding good. A reset normally would solve a problem with the logic on the circuit boards that control the unit, but that doesn't sound like it worked.
According to Schwinn, the troubleshooting procedure for a treadmill that won't turn on are as follows: Make sure the outlet is powered, it is plugged into the outlet, the device turned on by the switch and the safety key is in position. pretty elementary stuff - but I included it because that's what the manual says to do.
I can suggest the you try unplugging the power cord from the outlet for a minute or two, then plug back in & try to start the treadmill again. Sometimes that is the only way to be sure that there is no power reaching the circuit board(s) to perform a reset of the logic. If the circuit board(s) remain powered they can be "locked up" and will not allow normal operation of the device.
If unable to get the treadmill to run, you'll probably have to contact Schwinn Customer Support for assistance. You have a choice of ways to contact them as shown
here.
I hope this got you going - or at least pointed you in a direction to get help. Please rate my reply. Thank you.
