20 Most Recent Konica Minolta Bizhub C550 - Page 6 Questions & Answers

C255A Magenta TCR sensoradjustment failure"A" code not valid

Power supply cooling fan failure

CHECK TO SEE IF THE DRUM UNIT IS IN THE CORRECT POSITION

HiThis is the Error Correction Mode [ECM] which is turned off when data is being sent.Fax machines use it to communicate with each other making sure the sent data is free of errors.This feature turns itself on automatically after transaction is completed.Try turning V34OFF to [yes] and ECMOFF to [yes].

help me my konico minolta bizhub 184/164 error (C2558) my mail id - [email protected]

Must installed hard disk

KONICA MINOLTA BIZHUB 211 FUSER UNIT 230V / 4034r70100 (surplustoner.com) Here is the image of the fuser

Open the mid section of the copier and pull out main section. Then re-install. The code mean the the fuser (The large device on the left hand side that melts or fuses the toner to the paper is not connecting properly to the electrical connections in the back where it plugs into. Could be that the connector is broken because some slammed the mid section to hard. Or that you need to give the section a better/some what harder push when you close it. Might want to remove the FUSER unit and put a flashlight to the back make sure the connector is ok and check the connector on the fuser itself!

Check all fans located inside the machine

Replace the drum and developer. Clear the associated counters first in service mode. Then replace the developer and drum then run the F8 procedure in service mode.