20 Most Recent
Lanier LF310 - Page 10 Questions & Answers
My copier ran out of toner, I replaced it with a
There may be a clog in the toner supply unit, if you have a small vacuum made for copiers vacuum the toner supply unit and see if it corrects the problem if not you may need a new toner supply unit. Hope this helps
In Lanier GX3000 I would
The printer requires that all of its ink cartridges have ink before printing, the color ink cartridges will have to be replaced.
Service code sc523 , copier wont work
Ok. Try this procedure:
Press yellow key.
Press 107 on the key pad
Press red key at least 5 sec.
Press "copy SP"
Press 5810 on the key pad and press #
Press "execute"
Exit all the way out and turn the machine OFF and ON.
If this do not work i advise you to call a technician to see whats going on with the Fuser Unit.
It could be a faulty Thermistor...
Service code
Welcome to Fixya
Try to reset the system back to the factory state. Here's the procedure:
System Setting Reset
The system settings in the UP mode can be reset to their defaults. Use the following procedure.
1. Press User Tools/Counter .
2. Hold down the '#' key and then press System Settings.
3. Press yes when the message prompts you to confirm that you want to reset the system settings.
4. Press exit when the message tells you that the settings have been reset.
Thank you for using Fixya! If you need further help, reach me via phone at
https://www.6ya.com/expert/elixirjose_00375ea24bd8141b
I have a Lanier 116cn
The
machine have problem with the transfer roller or the motor which drives
the transfer is overloaded,
see do the right door is closed good
if
this not helped it will need to be checked by a technician.
Paper is solid black when trying to copy
make sure the top lamp lights when you press the print key if the lamp does not come on check the lamp harnes, the fuse, the lamp and the exposure board replace if either is faulty
Our ld090 copier keeps reporting
If there is no paper inside, maybe the problem is with some sensor. Exit sensor maybe...
But you also can see somethings. Make sure that the doors are well closed. If you have an open switch (door switch) the machine don't change the first message (that is "jam").
I have a lanier ld122 copier/fax. It told me to
First of all check if the doors are well closed.
If everything is well closed you can have several problems:
1º Toner supply defective.
2º TD sensor defective
3º Development unit defective.
If you don't have technical training i advise you to call the provider.
Not finding what you are looking for?