20 Most Recent KitchenAid KUDS30FXSS Builtin Dishwasher - Page 2 Questions & Answers

first ensure your machine is not set to half load, as this may only run the bottom shelf and not the top. also check the wather sprinkler rotor is not blocked. remove it and check the holes are free from debris.i hope this was useful

See my problem and solution. Sounds like you, too, are having a problem with the main control board (computer chip that controls the dishwasher), which is apparently a common problem with this model dishwasher. The part can be found here, for $211 (tax + shipping), and they have a 30-day return policy in the event that it does not fix the problem. It's an easy DIY fix. Hopefully this helps!

See my problem and solution. Sounds like you, too, are having a problem with the main control board (computer chip that controls the dishwasher), which is apparently a common problem with this model dishwasher. The part can be found here, for $211 (tax + shipping), and they have a 30-day return policy in the event that it does not fix the problem. It's an easy DIY fix. Hopefully this helps!

Sounds to me like a plumbing issue. Might have to try another plumber.

here is a link to installation copy and paste https://www.manualslib.com/manual/931286/Kitchenaid-Kgct305bwh0.html?page=2#manual

It sounds like the water inlet valve has stopped letting water in. With no water the spray bar won't rotate as it is driven by the pump. Generic videos.

Same issue here. WHAT WORKED FOR ME was simply unplugging the dishwasher for 15 seconds (no idea if 15s necessary), and plugging back in. Viola!

If the hole is small you can seal it with epoxy putty. Clean and abrade the area and after mixing the putty make sure it is pushed well into the hole and if possible smoothed over on the underside. Two types that will work.

J-B Weld Waterweld Epoxy Putty, 57-g ' Canadian Tire

https://www.canadiantire.ca > ... > Adhesives Waterweld Epoxy Putty allows you to make permanent repairs in moist or under water applications,Will fully cure in 60 minutes and will adhere to most ... Rating: 4.2 · ‎106 reviews

• J-B Weld SteelStik Epoxy Putty Stick, 57-g ' Canadian Tire

  https://www.canadiantire.ca > ... > Adhesives J-B Weld SteelStik Epoxy Putty is a steel-reinforced epoxy putty stick that is great for use on automotive and machine parts, exhaust systems, plumbing, .. ..

I couldn’t find any error code 2H but I did find an error code H2O. This code means insufficient water pressure. If the display reads 2H, it usually means the start delay function is turned on. The dishwasher will turn on in 2 hours if door is closed. This dishwasher is advanced. To understand all operations you should read the user guide or manual.

Do a hard reset and it should work..if not then replace the control board. http://www.ehow.com/how_7488137_reset-kud101flss6-dishwasher-control-lock.html

Pick any 3 consecutive keys (except Start or Cancel, then press them in the sequence 1, 2, 3, 1, 2, 3, 1, 2, 3. The dishwasher will go through a self-test and short cycle, and reset itself.

Question edited for clarity. Question moved from Miscellaneous. Create upward pressure as you are undoing it. You may be able to make it grip.