Top 20 Linksys Wireless-G WRT54G Router Questions & Answers

Here is a link to the Linksys WRT54GL Wireless-G Broadband Router support site with manual and firmware downloads

have you tryed bridge mode on the modem which device is doing the routing dhcp only one can do the dhcp is the internet light lit on the router, the router is set for ppoe for dsl try turning off dchp on the router let the modem handle

Try a different ethernet cord if you haven't already.

I'm sure your answer lies in the prior advice. However, from time to time, it is worth checking: http://downforeveryoneorjustme.com/

Pull the Linksy out of the console of your computer then re-install it. You may need to press and hold down your router for 30 seconds and then re-press.

Interesting theme. read about it in: Set up security key for wireless network Windows Help Continue In3 How to Set Up and Configure Your Wireless Router Set Up Secure Wireless Network in Windows 7

Access the settings menu for either the IP address or the MAC address.

First of all, please make sure that the router is properly reset. After connecting it to the computer, you can access the console to change/add the password. If you need help call 1-855-615-2280.

Follow these directions: How To Setup the Linksys WRT54G Wireless Router for EarthLink DSL

http://support.linksys.com/en-us/support/routers/E800

You have to do it thru the Internet. Google Linksys and go to the root IP address of the new router. Should be listed in your instructions too.

Perform a full reset of the router. With the power plugged in, press the reset button for 30 seconds; keep the reset button pressed and pull the power plug out for 30 seconds; keep the reset button pressed and plug the power back in. The unit will reset to the factory settings. User the software and instructions that came with your router, or download them from the Linksys website, and log onto the router and use the setup program to finish the setup.

Please follow the instructions found here: http://portforward.com/english/routers/port_forwarding/Linksys/WRT54G2/Shareaza.htm

My first instinct is to do a hard reset of the device, if you haven't done this yet. To do this you need to press and hold the reset button on the back of your device for 10 seconds. This will completely reset your device back to factory. Of course, you will loose all security settings, and these will need to be re-entered into the router.

Sometimes there is a reset button, which can be held by the point of a pen (or search online for your exact product manual or advice about where it is). Once it is reset, it will go back to the default password which often is 'admin' Again you can look it up online.

if you own your own wifi router, please go to the settings and set the wireless access to Open. This is not advisable to prevent people from snooping/leeching on your wifi, probably drawing considerable bandwidth at best or causing destruction to property at worst.

Call Linksys & they will walk you thru it Think there in Toronto,but like most calls could be anywhere

Main board fault. Contact the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/

Use the credentials: User Name: admin Password: admin Hope it helps.