20 Most Recent Zebra Stripe S400 Label Printer Questions & Answers

unter the withe roller, between the sensors thougnt printhead. the ribbon have to be on tope the sensors, not same path as paper otherwise, will come with no ribbon error.

el codigo de barras sale corrido de su posicion

Hola Carlos, dime en que puedo ayudarte, puedo darte soporte tecnico y surtirte refacciones.

Roberto Martinez
[email protected]

lucie_dibble: Maybe this is a electronic mainboard problem, try a printer reset pressing and holding PAUSE and FEED buttons then turn on printer, release buttons until all leds turn off. If this not work then replace the mainboard.

Roberto Martinez
[email protected]

Just a thought, Zebra Ribbons are Coated Side Out. Take a piece of tape and press it against the ribbon, ink should come off on the tape. If not then make sure the ribbon is the correct type and that you have it loaded properly. Also, if you use multiple ribbons i.e. wax, wax resin or resin make sure that you have the correct ribbon for the media installed. Hope that [email protected]

• This may be what you're looking for:
• 
  
• Please reply if you have any more questions. Good Luck! Please give a thumbs up if I helped, I am two votes away to becoming an expert!

After you calibrate the printer. Press feed a few times. If it feeds a single label each time, then the calibration was successful.Power off and on while holding the cancel button. (config printout). Keep config for reference. Send label print from computer. If it does not work, then check that the printer driver matches the config printout. The computer printer driver will change and overide the settings in the printer

load the paper and the Ribbon CORRECLY, check if the ribbon is not on top of the label sensors and gap sensors.
run manual calibration, press the last button until flash 3 times (to save), turn printer off, and on again.
If presist, download the correct driver (www.seagullscientific.com) run Reset to Factory Defult) from this driver.

SET/UP EXIT

Hit the "+" quite a few times until you get to "MEDIA POWERUP"

Hit SELECT

Use the +/- keys to enter the password (1234)

Hit SELECT - you should see a small - and + button on the screen on either side of MEDIA POWERUP (if not, repeat previous steps)

Hit the + sign until you get to NO MOTION

Hit SELECT to exit MEDIA POWERUP

Hit the + button to go to the next item HEAD CLOSE

Hit SELECT - you should see a small - and + button on the screen on either side of MEDIA POWERUP (if not, repeat previous steps)

Hit the + sign until you get to NO MOTION

Hit SET/UP EXIT to save changes (permanently)

Open and close the printhead to check to see if it worked!!!

If you GOOGLE "zebra s4m manual" you find a number of manuals you can download as a PDF and the instructions for loading the paper is in that manual.

Ve aqui y busca lo que necesitas -> http://www.zebra.com/id/zebra/na/en/index/service_support.html

I think you may have a deffective printer, to arrange a service call, contact www.lancerlabels.co.uk

Remove the ribbon. Load the direct thermal stock. Power the printer down. Count to five. Return power to the machine and then press the calibrate button (go throught the calibrate sequence). If that does not work. Let me know. There is a way to return to factory defaults and it should sense when you have a ribbon loaded and go to direct mode automatically.

bad print head.