20 Most Recent
Zebra 105SL Thermal Label Printer - Page 2 Questions & Answers
PRINT WILL NOT STAY ALIGNED ON EACH LABEL-RUNS ONTO NEXT LABEL
Check the tension on the Ribbon Take-up Spindle there is a nut on it that sometimes can loosen or tighten its self and will throw off the lables. Its a nut that has a of couple Hex nuts on the corner, screw the nut to about the 3rd thread from the top of the bolt facing you then tighten the hex nuts on the corners of the nut. Then try printing the labels make sure the media guide also is set to the lable size that is installed.
All labels are printing at a reduce size how do I change?
Hello there,
You normally configure a label size from 2 places:
a) Printer Driver(I reccomend downloading the one from Zebra from www.nicelabel.cl)
b) Directly from Printing software option
In both cases, search for the "Genera"l tab and you will be able to configure the label size
Cutter jammed
if you take the side off, and then the power supply, you will see a sensor and a flag, check for wear / damage. sometimes the allen bolt that holds the lower cutter linkage can come loose. try cleaning the sensor. also the connections from the cutter board need cleaning with ipa. if that doesnt solve the issue, you can take the cutter off, remove the silver plate and remove any label debris. if all this fails to solve the problem you will probably require a cutter board or sensor.
Printing half label
halp left or half right?
Try driver from www.seagullscientific.cam driver, it will help to reset to factory default., turn off and on, do the pause test and if still doing that, printhead need to be replaced.
Print Head Open Error
the flag inside the printer was moved out from sensor, you will have to adjust and tied the screw a litl bit as well.
I loaded the windows update
You need to get the manual for this printer, it has a printing language all it's own. The encoded text tells it where to put the bar code on the label, how to encode it, what text to put under it, etc. It's looking for a specially designed print file that's plain text. There may be a way to turn that off and turn it into a bitmap printer, but you would need the manual for that.
Not finding what you are looking for?