20 Most Recent TP-LINK TL-WR1043ND Router - Page 3 Questions & Answers

Connect the router to the modem with an ethernet cable, CAT 5, 6 or 7. Try amazon.

Reset and than re install internet provider settings

Have you contacted the phone company so they can activate it?

http://www.tp-link.com/en/ This will assist!

Hi, I have to assume you are referring to TP-Link power line adapters. In any event, pick the one that is not working. Press and hold the Pair button for a second or so, the Power LED will start flashing. Wait 2 minutes, then press and hold the Pair button of your main (other) TP-Link for 1 second, the Power LED will start flashing. In about 2 minutes all should be good. If not you may have to reload the flash software or use the disks to reset. Cheers

If you don't have access to the settings the handset is using to select the security protocol, or know what they are, the issue is probably with the protocol the handset is using to connect to the wifi, Check the computer that can connect, to see which protocol it's using. Then, I'd try a support ticket with the manufacturer of the handset to see if the issue is resolvable. It really depends on how flexible the handset protocols are...None, WEP, WPA2-PSK (TKIP), WPA2-PSK (AES), and WPA2-PSK (TKIP/AES) are all different options. Choose the wrong protocol, and you can't connect.

Google has many different ip addresses. They have servers I guess you call them everywhere. I downloaded several apps that looked up IP addresses cause the ping had different ones I didn't use. They all led back to GooGle owning that address. Nothing to be alarmed about, theres just no escape from Google, they see everything, track everywhere, and won a lot of different IP

this document should explain what to do http://www.tp-link.com.au/resources/document/VPN_Config_Guide.pdf

If all devices say they are connected then check the Internet light on the router to make sure it's lit. It usually looks like a little globe. They may be connected to the router but the wireless is not connected to the Internet. Try unplugging the router for 30 seconds anf then plugging it back in. If that doesn't work call your service provider.

Reset it with the pin hole on the back or the bottom. Everything will change to factory defaults.