Top 20
NorStar BayStack 425-24T (AL2012E41) 24x10/100 Mbps and 2x1000 Mbps Networking Switch Questions & Answers
Baystack 425-24T Port 26 disabled
I did what you sugget. Went to CLI and did :
conf t
stacking-mode disable
boot
After the reboot, port 26 is enabled and working. Thanks
Baystack 425 flashing amber on all ports
Make sure you're using the correct console cable...if it's not wired correctly, hyperterminal will continue to give you a blank stare no matter what you do. A great way to verify your cable is to try it on another switch that's working ok. Your hyperterminal comm settings should be 9600 baud, 8 data bits, one stop bit, no parity, and flow control disabled...assuming no one changed the default console settings on the switches.
If you are still having trouble getting a prompt from the console, you can try the following procedure, although this is only known to work on earlier versions of the Baystack switches...
Shut down the power and wait for about a minute. With hyperterminal connected...turn on the power and type "NetICs" (don't include the quotes) within 15 seconds of turning on the power. This should place you in a privileged mode and allow you to use the menu to reset the switches to factory defaults. Good luck!
Gbic
Hi from the command line interface you will need to login and then type enable (enter) configure (enter), interface fast ethernet all (enter), no shutdown port (port #).
Here is a link to the CLI manual if you need more help:
http://www116.nortel.com/docs/bvdoc/baystack/doc_pdf/217152-A_CLI_Guide_for_Ethernet_Switch_325-425_Release_3.5.pdf
Let me know how it goes or if you need more help.
Regards
How can i test the battaries in the ups battary
Hi Yazan,You need a battery tester in order to test the amps that a battery would output. From your description, they are at their end of life and you will need new buy new ones.Reply or call if you need more help with this -- 800.260.2259
9/7/2013 8:57:31 AM •
NorStar...
•
68 views • 0 helpful votes
Onity machine error showing no valid data connect to pc , what can i do for that ...
Here are some steps you can take to troubleshoot and resolve the issue:
Connect the Machine to Your Computer:
First, ensure that your Onity key machine is properly connected to your computer. You can use either a USB or Ethernet connection, depending on your machine's configuration.
Be cautious not to damage any of the connections while setting up.
Launch the Access Control Software:
Once the machine is connected, launch the access control software provided by Onity.
Double-check that all the information (such as username and password) is correctly entered.
Select the "Reset" Option:
From the software's main menu, choose the "Reset" option.
You'll be prompted to enter an authorized user ID and password assigned to the machine's operator account.
After verifying these credentials, you can enter the reset mode.
Input New Credentials:
While in the reset mode, input new credentials for the machine.
Set a unique password and click "OK".
Remember this password, as you'll need it each time you use the key cutting device.
Confirm the Reset:
Confirm the reset by clicking "Yes" on the confirmation prompt.
Wait until the process completes successfully.
The machine will reboot automatically after a few seconds.
If you encounter any issues during this process, consider reaching out to Onity Tech Support for further assistance.
I can't leave a comment after logging in..
Anywhere in particular? You seem to managing just fine here!
https://www.fixya.com/users/atos-maximus
For some strange reason you are answering Solved questions from August 2012??
..
Not finding what you are looking for?