Top 20 Lewmar V700 Vertical Windlass - 12V 1/4" W - Page 9 Questions & Answers

Here ya go. https://www.manualslib.com/manual/73462/Humminbird-110-Fishin-Buddy.html

Used about $200, new more like $600.

From other forums, the transducer seems to be a problem if it isn't pointing directly down when the boat is in the water.

I usually see 14.5 volts as a norm, but based on this site, you can see up to 15 volts for charging. If you are at 14.8, are you basing your overcharge on that or is there something else going on like boiling the water in the battery?

You can try here. There is a cost however. http://www.selocmarine.com/product_finder.php?Engine=5929

You can search for these using google and see the range from $200 used to $600+ new

no country stated prices all thing vary by LOCATION .lawrance h d s 5 x a fishing boat posted to computer repair help, oops moving you.

There is no oil filter.

Water has much more resistance than air, therefore slower prop speed. Are you sure there is a problem? Or possibly if their is a problem, weak battery, or corrosion. Clean battery terminals first, then try in water.

It's a difficult one to find, but Humminbird should have one. Contact them by clicking here and filling out the request.

moved you out of computer repair to boats why not just shop on line. but a mooring cover, you meant but right?

I think you have the Terrova model. The link is to manuals. Perhaps there is more info on the motor to identify which one of the three you have, such as volts. https://www.minnkotamotors.com/support/manuals/trolling-motors/terrova

Sounds like there is a blockage in the fuel line that lets gas through for a short period of time, then becomes very low and the engine stalls. Look for dirt in the lines and clean out.

The on/off is a designated with a circle with a line down through the top. See here for manuals. https://support.garmin.com/support/manuals/manuals.htm?partNo=010-01550-01&language=en&country=GB

Common changes involve a new connector that fits the unit and splicing in the old cable. If the old cable is 10+ years old, I would replace it.

There is a model 60452 listed under 60hp, 1964year. Not sure what the S means, but in the 60's they were 2 cycle. I don't think 4 cycle came out until the 80's. Evinrude Outboard Motor Model Numbers

Sounds like the prop is cavitating when air gets by the prop. Perhaps this is happening when the water is more rough and the boat is bouncing more.

Make sure you have the correct ring. This may help:

PLEASE LOOK INTO THIS LINK <https://www.manualslib.com/manual/624841/Xantrex-Tc1012.html>

I don't know much about the air shot. I do know that Wellcraft was one of the best boat building companies. Since the hull design really didn't stick around, it may have been more expensive to make with some improvement in how the boat planes and takes waves. Kind of like a tri-hull.