Top 20 Lewmar V700 Vertical Windlass - 12V 1/4" W Questions & Answers


I would check the wire leads off the windless to switch and from switch to battery (typically ground) During times of extreme load thoes thick wires heat up expand and contract and might loose a little contact or corrosion. Thoes windlesses are pretty bullet proof and very rarely have i seen one break. So I don't think its the winch itself. I would start there. Good luck Aloha

Lewmar V700... | 79 views | 0 helpful votes


Pins are splayed on the end to keep them from coming out. Remove entire hinge or drill out pin and replace, remembering to peen the end again.

Lewmar Boating | 682 views | 0 helpful votes


The higher pitched prop will give you faster top end speed.
however you will lose low end torque.

Boating | 30 views | 0 helpful votes


Water has much more resistance than air, therefore slower prop speed. Are you sure there is a problem? Or possibly if their is a problem, weak battery, or corrosion. Clean battery terminals first, then try in water.

Boating | 34 views | 0 helpful votes


Need to strip it down and check the motor or any seized parts.

Also check that you have a return as well as a live feed. IIRC, there is one live and two returns, one for up and one for down.

Google the model number and the words 'parts schematic'.

Boating | 31 views | 0 helpful votes


Haswing would be a possible source.

Boating | 21 views | 0 helpful votes


Rebuild or adjust the carburetor

Boating | 25 views | 0 helpful votes


manufacturer --marine shop --online search

Boating | 18 views | 0 helpful votes


WEIGHT IS NOT A FACTOR. IT IS HORSEPOWER Rating that you need to worry about

Boating | 21 views | 0 helpful votes


can you fabricate a real sentence?

Boating | 17 views | 0 helpful votes


Take it for tune up and service. These days they have electronic fuel injection. An Evinrude dealer can hook it up to a computer and check fuel mix.

Boating | 18 views | 0 helpful votes


The anodes when attached directly to an unpainted area of an aluminum hull will protect any part of the hull that is not electrically isolated from the anode.

https://goneoutdoors.com/attach-zinc-anode-aluminum-boat-5856438.html

Boating | 23 views | 0 helpful votes


When I worked boats years ago. We had a brand new boat gettin water in it. Finally found that the bell housing had a porrous casting in it allowing water to seap in from the exhaust port.

Boating | 28 views | 0 helpful votes


they go on small boats

Boating | 21 views | 1 helpful votes

Not finding what you are looking for?
Lewmar V700 Vertical Windlass - 12V 1/4" W Logo

3 questions posted

Ask a Question

Usually answered in minutes!

Top Lewmar Boating Experts

ray gallant
ray gallant

Level 3 Expert

63068 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

26841 Answers

Tom Chichester

Level 3 Expert

51932 Answers

Are you a Lewmar Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Lewmar Boating

  • Lewmar Boating

Most Popular Question

during hauling in operation windlass

  • Boating
Loading...