Can u help me....
It takes only a few steps to program a Jensen Universal Remote Control, but you need to know the code of the component you are programming into the remote. You can get the code from the manufacturer of the component, or you can do an online search to find it. Make sure to include the make and model of the component you want to program and the model number of your Jensen remote in your search so that the two are properly linked.
1. If you know the code for the component you want to program, turn the component on.
2. On the remote, hold the Device key down until the green indicator light comes on.
3. Release the Device key. Then, within 30 seconds, enter in the three-digit code number. The light will flash when the right code has been entered.
4. Press the Power key. If the component turns off, you have entered the right code.
If you don't know the code, you can do a manual code search and entry using your remote:
1. Turn on the component
2. Press and hold the component key (TV, DVD, VCR-AUX, SAT-CBL). The illuminated on-off key turns on and stays on.
3. While holding the component key down, press and hold the ON-OFF key. The illuminated ON-OFF key turns off.
4. After holding down both keys for three seconds, the illuminated ON-OFF key turns back on.
5. Release both keys. The illuminated ON-OFF key remains on.
6. Press and release the ON-OFF key repeatedly until your component turns off. Wait four seconds between each keypress. Each time you press the ON-OFF key, the illuminated ON-OFF key blinks, and the next code in the list is sent. This process continues until all of the codes in the code lists have been searched. If your component turns off, you have found the correct code. (If it cycles through and the illuminated ON-OFF key blinks four times and turns off, all codes have been searched. The manual code search method is exited.)
7. Once you have found the correct code, you must save the new code by pressing and releasing the STOP key. The illuminated ON-OFF key turns off. You must press the STOP key to save the code or the correct code will not be saved.
8. To confirm that the component is programmed with the correct code for max functionality, test the component. Attempt to control a variety of the component's functions with the remote. Hopefully, everything will work without having to repeat the process. It's also a good idea to retrieve the code your remote programmed and write it down for future reference. If you don't know how to do this, do an online search for the manual for your particuar Jensen remote, and the procedure for code retrieval will likely be described in it somewhere.
Hope it all works out so you can view your media in peace ~