20 Most Recent NordicTrack Treadmill - Page 9 Questions & Answers

Double check: Chances are that "$%#T Happens" is not your problem. And that if it worked prior to "dis-assembly, it should work after re-assembly". The common denominator is you took it apart & put it back together. So.. something was missed. A wire not connected, a switch not flipped, a wire in the wrong spot, the safety key not in the slot, etc, etc. Good Luck

Don't know why you would need to up the supply power what is the mains power meant to b it could b motor or start up capacitor on motor if fitted

did you test the reed switch to see if it working? and check the connection on the board

do you hear the motor running but the belt is not? if it is the belt need tightened or the drive belt may have broken. remove the motor hood to inspect

first check and see what the circuit is rated at. it you have too many thing on that circuit(light,tv,etc) this will trip your breaker because of the amp draw of the treadmill. nordictrack recommends a dedicated circuit of 20amp. you may nned to have a circuit put in with 12/2 wire

if the walking belt slips there are adjustment bolts at the rear.one on either side. turn each one about a half turn then recheck.

check and see if the wire got caught anywhere making it short

try pushing up on the walking deck to relive the pressure the pull the knob out to lower

check the upright wire that run up the right upright. make sure it is connected at both ends and there are no bent pins

if you mean the walking belt. is it slipping? if so there are two bolt at the rear of treadmill that need tightened to remove the slack in the belt