Yes it could, but... but it also depends on your antenna, what antenna are you using. Do not upgrade the power of your radio unless you know your antenna can handle the output power.
How To Clone a BPR40 Radio Cloning duplicates the contents of your radio (master radio) into the new radio (slave radio). Tuning and alignment information are not affected by cloning.
Set Up the Master Radio
1. Turn off the radio. 2. Press and hold Programmable Button 1 (the top programmable button) and turn on the radio. Keep pressing the Programmable Button 1 until beep is heard twice. 3. Release Programmable Button 1. Notice the LED changes to RED
Set Up the Slave Radio 1. Turn off the radio. 2. Press and hold Programmable Button 1(the top programmable button) and turn on the radio. Keep pressing Programmable Button 1 until the beep is heard three times. 3. Release Programmable Button 1. Notice that the LED changes to GREEN
BPR40 Radio to Radio Cloning Procedures 1. Connect the cloning cable to both the Master and Slave radio. 2. Press and release Programmable Button 1 of the Slave radio. 3. Within 2 seconds Press and release Programmable Button 1 of the Master radio. 4. The LED for both radios show flashing orange during cloning. 5. Once cloning is completed, an
Did you ever solve this? I have one headset that will not power off. It will not enter pairing mode, either. Curious if you had the same issue and if you fixed it. Thanks.
PDF
When the power is turned on in terms of a wireless meter the screen should display "SEr" ... the UIU, when correctly paired the screen will display "RF Con" with a "tick". 5. The meter can then ... this means that the tamper latch has not ... If you have signal and the RF CON message on a meter that was previously paired then ...
ystar: If the conlog meter is showing rf-Con, it means power supply doesn't reach the meter at all its either Loss of phase from the transformer or a loose contact ...
Jan. 22, 2018 · 3 posts · 3 authors
Asking for a friend, He is using a wireless electrical meter, however on the meter it says: rF con He said it's a conlog, so I googled it and...
Jul. 29, 2015 - The power meter is really easy to understand. However, the meter will also throw some error symbols on the same display which we already ...
IF it works, what are you questioning? It is rare for any antenna to have a flat SWR across the whole band. One has to ask what meter you are using and of course you know that you cannot measure SWR on SSB right?
If you are streaming music or video, it is the signal cutting out due to Internet connection issues.
If it is music from your phone, then it can only be two things
1. the earbuds are too far away from the phone. Try moving the phone closer, or move it to the other side of your body. The receiver is only in one ear bud.
2. they are faulty. Return them under warranty.