20 Most Recent Briggs & Stratton Prosumer 2800 PSI (Gas - Cold Water) Pressure Washer - 20324 - Page 9 Questions & Answers


For a repair manual, contact Briggs & Stratton directly.

Briggs &... | Answered on May 19, 2017


Sounds like your choke is stuck on or if there is a set screw on the carb you need to turn it in a little so you are not feeding it too much gas.

Briggs &... | Answered on May 07, 2017


Keep an eye on the oil level, it could be sucking oil past the rings and burning it causing the engine to run a bit faster. it may also have a small vacuum leak at the carb or manifold tube, make sure the carb and manifold gaskets are not leaking air. All combustion air must pass through the carburetor exclusively.

Briggs &... | Answered on May 05, 2017


I do that on people's mowers when they come in not running fast enough. If they are running too fast I stretch them a little and even cut the end off the spring and reshaped the end to get the right speed. Yes you can do this but be sure you do not over rev the engine or you will ruin it.

Briggs &... | Answered on May 01, 2017


incorrect method of setting valve clearance find tdc with the valves rocking, exhaust just closing and inlet just opening--- known as valve rock-- now turn 1 full turn and both valves will be fully closed
adjust the clearance to .010" inlet hot and .012" exhaust hot the noise you hear is clearance too wide

Briggs &... | Answered on Apr 25, 2017


on tillers the control cable lengths need to be kept the same as they use the free end cable lengths to denote how much pressure is put to clutch pressure idler wheel , too long not enough pressure, too short too much pressure

Briggs &... | Answered on Apr 20, 2017


This is an indication that a valve is bad.

Briggs &... | Answered on Apr 01, 2017


The other one Goes to the power supply positive side

Briggs &... | Answered on Mar 25, 2017


check that all the safety micro switches are fully operational to get it to start
sit in seat , foot on brake cutters not engaged etc

Briggs &... | Answered on Mar 04, 2017


It could be the battery is just no good. I had mine do that and I took the battery to have it checked and they said it was ok and charged it for me came home started right away but after I turned it off it wouldn't start again so I went and got a new battery and have not had that happen again.

Briggs &... | Answered on Feb 12, 2017


Only need a simple double pole, single throw toggle switch. One side to power (battery) other to solid ground, to run power to starter motor Starter motor may have a ground on it also. See u-tube video, starting a riding mower.

Briggs &... | Answered on Feb 12, 2017


as you cannot describe the problems take it to a mower shop for repairs

Briggs &... | Answered on Jan 30, 2017

Not finding what you are looking for?
Briggs & Stratton Prosumer 2800 PSI (Gas - Cold Water) Pressure Washer - 20324 Logo

2 questions posted

Ask a Question

Usually answered in minutes!

Top Briggs & Stratton Garden Experts

John Trevino

Level 3 Expert

1407 Answers

wadingriver
wadingriver

Level 3 Expert

2223 Answers

JOHN LAPIER

Level 3 Expert

2591 Answers

Are you a Briggs & Stratton Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Briggs & Stratton Garden

  • Briggs & Stratton Garden

Most Popular Question

when adding sae 30 oil new pw add

  • Garden
Loading...