20 Most Recent Briggs & Stratton Prosumer 2800 PSI (Gas - Cold Water) Pressure Washer - 20324 - Page 10 Questions & Answers

0helpful
1answer

Hi, I have a 13.5hp Briggs & Stratton motor which starts and will only run on choke slow rpms and mild smoke.

check the point where the fuel hose goes to the fuel tank there is very fine filter in the hose that could be blocked preventing full fuel flow only running on choke indicates insufficient fuel flow
5/19/2017 9:21:18 PM • Briggs &... • Answered on May 19, 2017
0helpful
1answer
0helpful
1answer
0helpful
1answer

Why does my Briggs & Stratton mower engine struggle to start and does not reach full power and spark plug goes black after fitting new one

Sounds like your choke is stuck on or if there is a set screw on the carb you need to turn it in a little so you are not feeding it too much gas.
5/7/2017 7:10:48 PM • Briggs &... • Answered on May 07, 2017
0helpful
1answer

Why is my 450 series 148cc briggs and stratton lawn mower engine running fine and then when it gets hot it runs with no throttle

Keep an eye on the oil level, it could be sucking oil past the rings and burning it causing the engine to run a bit faster. it may also have a small vacuum leak at the carb or manifold tube, make sure the carb and manifold gaskets are not leaking air. All combustion air must pass through the carburetor exclusively.
5/5/2017 7:15:56 AM • Briggs &... • Answered on May 05, 2017
0helpful
1answer

Tight throttle spring on briggs ok?

I do that on people's mowers when they come in not running fast enough. If they are running too fast I stretch them a little and even cut the end off the spring and reshaped the end to get the right speed. Yes you can do this but be sure you do not over rev the engine or you will ruin it.
5/1/2017 1:26:12 AM • Briggs &... • Answered on May 01, 2017
0helpful
1answer

Lots of ticking noise in valves, replaced head gasket, blowing smoke, replaced needle and seat gas flooding crankcase, Any one know why it ticks so bad?

incorrect method of setting valve clearance find tdc with the valves rocking, exhaust just closing and inlet just opening--- known as valve rock-- now turn 1 full turn and both valves will be fully closed adjust the clearance to .010" inlet hot and .012" exhaust hot the noise you hear is clearance too wide
4/25/2017 9:59:11 AM • Briggs &... • Answered on Apr 25, 2017
0helpful
1answer

Briggs & Stratton 35 Classic rotorvator. How to fit drive cable to drive the tines. Help!

on tillers the control cable lengths need to be kept the same as they use the free end cable lengths to denote how much pressure is put to clutch pressure idler wheel , too long not enough pressure, too short too much pressure
4/20/2017 11:30:02 AM • Briggs &... • Answered on Apr 20, 2017
0helpful
1answer

Sorry about that I wanted to know if the coil on a lawn mower Briggs & Stratton should have continuity

yes and resistance in the reading
4/19/2017 10:30:28 PM • Briggs &... • Answered on Apr 19, 2017
0helpful
1answer
0helpful
1answer

Briggs model 446777 0244-E1 26hp twin running hot on #1 cylinder also popping

This is an indication that a valve is bad.
4/1/2017 1:13:17 PM • Briggs &... • Answered on Apr 01, 2017
0helpful
1answer

I need the wiring diagram for a 12hp briggs and

The other one Goes to the power supply positive side
3/25/2017 10:52:39 AM • Briggs &... • Answered on Mar 25, 2017
0helpful
1answer

I have a Toro 8-32 briggs and stratton Engine

check that all the safety micro switches are fully operational to get it to start sit in seat , foot on brake cutters not engaged etc
3/4/2017 8:44:44 AM • Briggs &... • Answered on Mar 04, 2017
0helpful
1answer

How do I troubleshoot my Briggs and Stratton 11hp

It could be the battery is just no good. I had mine do that and I took the battery to have it checked and they said it was ok and charged it for me came home started right away but after I turned it off it wouldn't start again so I went and got a new battery and have not had that happen again.
2/12/2017 12:24:58 PM • Briggs &... • Answered on Feb 12, 2017
0helpful
1answer

How to wire up my 13.5hp coil & charging system

Only need a simple double pole, single throw toggle switch. One side to power (battery) other to solid ground, to run power to starter motor Starter motor may have a ground on it also. See u-tube video, starting a riding mower.
2/12/2017 12:16:02 PM • Briggs &... • Answered on Feb 12, 2017
Not finding what you are looking for?
Briggs & Stratton Prosumer 2800 PSI (Gas - Cold Water) Pressure Washer - 20324 Logo

2 questions posted

Ask a Question

Usually answered in minutes!

Top Briggs & Stratton Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Briggs & Stratton Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Briggs & Stratton Garden

  • Briggs & Stratton Garden

Most Popular Question

when adding sae 30 oil new pw add

  • Garden
Loading...