Top 20 Ctm HS 6200 Folding Power Wheelchair Questions & Answers

for that go to ebay in medical batterys for powerchairs

hi, that is the wigwag also known as throttle pot -- > error .. Now what can happen is the pot is no longer in the dead centre position when you turn the scooter on or the pot is worn giving incorrect resistance to the controller . can you see the end of the pot shaft , there should be a slot in the end of it , make sure that it is dead centre to the front of the scooter .. Regards Rob

ask them/? https://www.mobilityscootersdirect.com/mobility-scooters.html

notify manufacturer

you can try ebay

That type of fault can only be fixed by a dealer.

hi Brenda, it normally located at the rear near the controller, you will find like a black circular button type with a hole in the middle, covering up the hole will quieten it down, Please note, if you make it quiet and there is accident when you 're backing ? , at least people know you're there. Regards

Hi, Check the brushes in both motors. i know it going okay in forward but you be surprise , at worse it's a controller fault, Regards Rob Please leave feedback.

Here is the manual. I am still looking for the schematic. the manual does have a god troubleshooting section. http://scooterland.net.au/wp-content/uploads/2015/08/User-Manual-HS-589.pdf

Remove the top tiller console and check connections from membrane horn switch to horn. Test for voltage to the switch with a voltmeter. Check for voltage to the horn when the switch is pressed. These horns are inexpensive and easy to replace by splicing the wires and hot gluing the new horn inside the cover.Hope this helps

Hi try this +44 800 096 1296. good luck try this phone number they might have youre controller .............+61 3 9329 3666...... Cheers

hi Leslie, Sadly that is most likely a controller fault... Please contact me if in the uk as i offer a free testing service... Regards Rob

Hi ring monster scooter parts 800-798-0325 they should have them in stock .....good luck

Please let us know what the problem is so we can better guide you on what to trouble shoot. Example: ohms on motors, too much current? please advice or call CTM direct 909-590-1388 x 115

Raj, There are a number of causes for this. What is happening is an interruption in the signal going to the controller. One of the first things to check is if the throttle is self centering, the spring maybe broken, or more likely the throttle is sliding on the pot it is attached to. A wire maybe broken in the tiller harness. Loose connections to the motor can do this. Scooter Doctor App I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

Dead battery. U might have to get new battery(s) if present one does not hold a charge.

hi, Total Weight with Batteries : 197.8 Lbs. Regards Rob www.gewizrepairs.co.uk

No, you need the correct charger.

I would get the batteries checked for power. Just because your charger shows fully charged quite often the batteries are low but enough power for lights or horn which does not take much power. i suspect bad batteries.

code???