20 Most Recent E-Machines eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop - Page 8 Questions & Answers

plz check the manufacture website for the drivers

Here you can download the drivers

Please download cupz.exe from the internet and run the exe and you i will all the information regarding your system and motherboard and than try to find out the drivers for the same chipset ok.

hi there,

may i know the exact model/maker of your mobo.

i need manual for motherboard 14319 imperial_gv 20030812 thankz

Did you reinstall the sound card physycally on the main board or did you install new drivers?
You need to check the device manager (start-settings-control panel-system-select " hardware" tab at top, then click on device manager)
If you have your sound card listed in its category (sound, video and game controllers) or listed in the "other" category and it has a yellow ! next to it, you must right click on it and hit uninstall. one of those will cause the computer not to even look for the sound card for install because the computer thinks it's already installed , even if its wrong.
so if you see one of these, expand the + to see the device , then right click on it and select uninstall .
then procede to load the new driver. restart
Regards.

Please forward PC 400 mb audio driver alc201a

system board model t2984 emachines pc does not power on. how much for replacement board.

have to install the high definition audio bus driver first. Doesnt really matter where you find it, this one is from hp for example

http://h20000.www2.hp.com/bizsupport...reg_R1002_USEN

Then install

Audio - SigmaTel audio driver

from

http://support.gateway.com/support/d...&uid=196216183

Hi,
the soundblaster cards, usually have to set an interupt port IRQ.
This can sometimes conflict, with any other device connected i.e printer/paralel port.
I,d suggest, power off the computer. and remove the mains power cable. then completely remove the soundcard.
either try the card, in a different pci slot, if you have a spare.
or reboot the computer, without the card in at all.
shut-down, power off. re-insert the card and re-install.
also check, the on-board sound card is working correctly if applicable. you may have a conflict between the on-board and standalone ( soundblaster Card ) attempting to share the same driver or resources.
Finally check the motherboards jumper settings ( User Manual ) to enable/disable the onboard sound. if necessary.
And check the settings in BIOS.

Mike @ compurepair.

Use the WinXP cd and run a repair on the unit.

When you boot the XP cd, do not use the reopair on the first page. Click on install, then choose the repair option . I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Hi,
This is a tricky problem. You would be thinking that if green light comes then everything is working fine. But that doesn't satisfy the system. Make the ATX power connector of SMPS(Single Mode Power Supply) is properly plugged in or not. The glowing of green light because of the small power connector (4-pin square connector) beside the processor fan. There is one more power connector i.e., ATX power connector. i guess its 20 pin. plug in properly and then try. If again the same problem occurs then you need to replace the SMPS itself.
Thank you........

try re-installing the drivers but use the drivers from here

http://www.realtek.com.tw/Downloads/downloadsView.aspx?Langid=1&PNid=14&PFid=23&Level=4&Conn=3&DownTypeID=3&GetDown=false

the sound chipset on your computer is based on the AC 97 audio chip, and Realtek are the best drivers, just select the correct one for your opperating system

use this site. select Product type, series, model
and u will get all the driver of ur machine.

regards,

i need your rating

just insert in the black coloured slot while insering see the cuts below the ram should coincide with the black coloured memory slots thats it just keep correctly on the slot and press it the white locks will lock at the end of the slot at both the side

Note wile putting insert from the end of the slots tht is u have gap at the end of the slot the RAM should go there properly

it means that there is something wrong in plug/pin that u are going to plug. so try with a different headphone. hope this problem with be cured.

regards,

no sounds or beeps rules out the hard drive, at this point it's either the power supply, motherboard, or cpu. Have you tried the power supply in a different machine? Also, eyeball the motherboard, specifically the capacitors, look for any that have bulges on the top.

Go HERE and download AVG AntiVirus and run a scan. It should sort the problem out. By the way, its free;)

Just scroll down to the 5th item - Free essential PC Utilities,and download AVG AntiVirus from there.

If you find that the solution/answer I provided led you to, or resulted in a fix, please close the ticket with a FixYa! rating under my solution. I would be very grateful for your show of appreciation.

Should you have any further questions, please feel free to post them here.

Thank you for using FIXYA!

Cheers!
IrishDruid

It sounds like the motherboard is toast

Didn't find anything on EBay for a motheboard

You can get a replacement Dell wo/monitor for $299 +Tax/shipping

http://www.dell.com/content/products/category.aspx/desktops?c=us&cs=19&l=en&s=dhs

Look at the board carefully and find what looks like a model number or brand.
eMachines does not make their own boards (at least didn't) so the info you seek will be available from the board manufacturers website.

Just as a tip though, it is nearly impossible to mis-connect the cables and devices.
Remember, this kind of stuff is being assembled by Chinese (former) farmers any more; it ain't that tough.