Sanyo DS27510 27" TV - Answered Questions & Fixed issues
Sanyo stuck on video mode
Yippie, I figured out a solution that worked!!! I have a univeral remote from comcast, on that remote near the bottom left is a small button that says (input) tv/vcr, press that one time and whala!! the tv video screen was gone, I had to manually change the channel from the tv channel button on the unit. once I changed the channel to 3, my universal remote worked... the button is the second one from the bottom left... I was on hold with sanyo for a long time and just kept trying on my own, so good luck!!!!
5/3/2019 1:28:44 AM •
Sanyo DS27510...
•
Answered
on May 03, 2019
•
13,584 views
Converter box
Any Anolog tv should accept a converter box. Just set the tv to channel 3 or 4 to pick up the signal from the converter box.
Ds27425 picture moved forward cannot read channel numbers
Sounds like picture have been shifted horizontally. If you want to adjust the horizontal position, you have to enter its service mode option, and to change the data value there. Contact any service technician. This is a skilled work.
If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience.
http://electronicshelponline.blogspot.com/
Service mode entry, adjust and exit procedure to many popular brand TVs are given. Never forget to exit the service mode, after all adjustments have been done.
NB: Please read and understand well, the instructions to enter the service mode, before you begin. Be very careful.
Note how to "EXIT" the service mode; after entering and adjusting data. This is very important.
Type in the brand name of your device, in the search box [at the top right] of the display window, and press enter to get all related posts. It will make surf easy.
Horizontal AND Vertical Hold Lost
It sounds that the synchronization separator section is faulty. In all modern sets, the section will be a circuit part inside the main IC. Therefore, check out, and replace that IC.
My tv is stuck on the blue screen .
Go push menu button on the front of tv or the right side.Pick the video out,or tv.Or buy a remote.Website 1-800-Remotes factory Original.For the original remote.
I have a 2002 Sanyo 27" TV DS27510, it was working
. There is a high possibility that the components over a period of heating and cooling, tend to bring on a problem of dry soldering. So my advice is to check the set for some loose joints that have played on to give you these erratic shut downs or poor performance. The best way to check for loose connections is to tap lightly when the set is powered on, if there is change while tapping then it seems that there are DRY solder joints. Remove main plug, the covers - with caution of high voltage, check for dry joints, and use a good soldering iron to solder all suspected points. Sometimes the fault occurs when the set warms up; if so you can simulate the heat using a hair dryer on the suspected areas, try with the power supply, distribution, Processor controller, driver controllers on the A/V related sections. Also the use a FREEZE-IT spray can simulate the components to cool and show up the fault. It can also be related to WEAK ELECTROLYTIC capacitors as the value can reduce in time.
How do u remove v
V guide or V Chip settings might be coming from your signal source rather than the TV itself. You might want to try contacting your cable or satellite company.
Not finding what you are looking for?