20 Most Recent Sanyo DS31520 31" TV - Page 2 Questions & Answers

0048.0042,0046. Try these codes. If you wish to get more information, check these links. Setup procedure, and setup code list to many popular remote controls are given. Pull up older posts. http://electro-medical.blogspot.com/ http://electrohelponline.blogspot.com/

Set-up codes to check are 1171 1298 1316 1347 1349 11431157 1172 1208 1360 1024 1115 1052 1232 1046. If you wish to get more, check the site linked here. http://electrohelponline.blogspot.com/ Pull up previous posts there, either by its left side bar, or view it in Mosaic / Timeslide option.

These are called blinking codes. From the number of blinks, you can get an idea about which section inside is faulty. For more details about blinking codes, visit this link.

Get a original one as Sanyo is not a brand most universal remotes will program for.

If it is latest tv check you have changed blueback option in menu(available in some model), then check the given source cable is proper. Suppose if it is old model there is dry contact in solder points. Otherwise make one general service by authorised service provider

Be aware if using a box for signal to the set it also has CC---look in menu on both set and box if a box is used.

you can do this without a remote if you have a menu button on the tv you can fix it from there. if no menu button the press the channel up and down buttons at the same time and the menu will appear. if you can not find the tv code for the remote(IF its a universal remote) then you dont need the code you just follow the steps to enter the code But dont enter a code just keep pressing the channel up button on the remote until it turns the channel on the tv when it does STOP hit the enter/ok or similar button on the remote a your remote will work like new on your tv.Hope this helps you out or atleast gives you an idea.Best of luck to you!!!! Good day

Make a Factory Reset to your TV. Refer its user manual for details. Unplug the TV from AC mains wall socket, and re-plug it into after 10 minutes or so. Then try again.

Replacing vertical output IC won't poise this type of problem. Check the voltages at the audio output section.

no you require the remote or a universal remote or sometimes a cable remote that has been programmed to work the volume on the tv set will have an input button .

Based on the specs for the TV, the DS31520 is not an HD-ready display. It is at best an SD display with an NTSC (analog tuner). (Picture resolution: 330 lines, video input 660 lines) OTA ATSC signals are 480i (SD), 720p or 1080i (HD) where those are the number of horizontal lines of pixels. The manual is available here: http://www.sanyotv.com/DS31520%20%28ESF%29%203178--.pdf .This is a fine TV for analog cable or OTA TV with a standard digital to analog converter box (which only give SD output). The TV has composite video and S-video inputs (again limited to SD). For HD, you will need a new TV screen that can display more rows of data. I wish that I had better news for you. Cindy Wells

Closed captioning is in the main menu. Use channel up/down and volume up/down on tv to navigate and turn off.