20 Most Recent
Sharp Aquos LC-37GD6U 37 in. LCD HDTV - Page 2 Questions & Answers
Cannot seem to set channel search
Can you get the whole menu screen to appear?
Can you navigate to the channel program mode?
If not, check the remote for weak batteries.
If all above is OK, but your problem persists, unplug the TV, wait a minute, replug and see again.
How to restore factory setting without remote
You will need access to the main user setup menu. With most model TV sets the original remote is required. Some of the high end universal remotes have the functions to allow access. It is best to always have the original remote for the TV set.
Why my LCD TV blinks picture and goes off when backlight is high
When you set the backlights to high it causes the inverter board to generate more energy, as well as consume more from the power supply, all the while both are generating more heat. If you have your set mounted (restricting the vents) and/or you regularly use the high setting, that could cause capacitors to bulge and leak due to excessive heat damage. I would open her up and have a look at the power supply and inverter boards. Check for bad caps or board surface discolorations.
Why does my sharp aquos lcd tv goes off when baclight is increased
Power supply regulator board fault. Check and replace damaged component/s at it main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Viewing it in "
Mosaic" or "
Magazine" will make surf easy. Surf the site with patience. Pull up older posts.
Do a search by type in the brand name of your device at its search box.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis.
Sharp tv not responding
If it does not Power up, even the front indicator light too is absent, the fault is with its main power regulator board. Check and replace damaged component/s at it main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Viewing it in "
Mosaic" or "
Magazine" will make surf easy. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis.
My hitachi 32ld8600 keep turning off after 4 minutes
This is a good indication that the capacitors on the power supply are failing. Is it under warranty? If so, contact Hitachi to find a certified service center. If it isn't, you will have to find somewhere to take it to get the power supply replaced or fixed.
Black cloud like fogged on Sharp Aquos 37"tv
If your LCD TV or monitor has stopped working, or is displaying one of the following symptoms, then it's a candidate for some new capacitors
- Flickering screen
- Screen image disappears after several seconds
- Dim screen
- Slow start
- Power LED on, but no picture
- Unusual colors and/or lines
The primary cause of LCD TV and monitor failure is caused by faulty capacitors. You can examine the capacitors in your LCD TV or monitor and actually see if they are bad.
If they appear bulged on top, then they need to be replaced.
New capacitors will solve a host of problems in LCD monitors and TV's and will extend the life of your monitor or TV by several years.
Check the cables, connectors and connections.
Take it to a repair shop.
I cant access my menu for my sharp/apuos 37 inch
Make sure there are batteries in the remote and that you are pointing directly at the TV. Also the settings button may not work on the remote, you can try a universal remote if that doesn't work.
Not finding what you are looking for?