Korg PA50SD Pro 61 Key Keyboard Bundle - Answered Questions & Fixed issues

Have the same issue

For the best info contact Korg customer support. Here is the link- http://www.korg.com/us/support/contact

It is power supply regulator problem. In the regulator circuit, DC 12volt from adapter is separated into +8V, -8V, +5VA, +5VD' Some causes when the unit hang / frozen is one of the existing supply voltage is drop. In general, +5V. Also check the adapter voltage, if still normal and the current is sufficient. Adapter must have DC12volt and current of at least 3 amperes. It may happen, when the adapter is measured without load, it's read normal,12v. But when loaded to turn on the keyboard, many voltage decreases (lets say,between 8-10v). This indicates that the adapter is not good.

Take it back to where you bought it, and get it serviced, to clean the dirt-filled contacts.

NOT a fuse... thaat person knows nothing. There is something wrong for sure. Check if one of the buttons or keys MIGHT be stuck down (depressed). Sometimes the units check that all the control buttons are up and they don't really tell you why they fail to start. Beyond this a repair shop is in order.

Question edited for clarity. It is a known issue, you need an electronics engineer. https://www.google.com/search?q=korg+m1+distorted+output ..

No one knows the fuse type, but the details should be on the fuse itself. Then you can't get them from an electronics store or Amazon. The Service Manual is in the link. https://www.google.com/search?q=Korg+n364+keyboard+replacement+fuse ..

See page 166 troubleshooting of user manual. It may help. 331ad6cf40f982ddcfbb201db1a6d34f.pdf (korg.com)

If you contact Korg, they can send you a dowloadable link to burn the software to a disc.

up to you if you ant to spend the money to have it diagnosed and repaired

$213 or take to an electronics service technician to diagnose which part got damaged and replace the component/s. https://reverb.com/au/item/69569832-korg-n364-n264-x2-x3-workstation-power-supply-board-assembly-part-klm-1633 https://www.google.com/search?q=Power+supply+board+of+Korg+X2 ..

Sounds like loss of memory\programming.Go to Korg website for download.

https://www.google.com/search?q=install+firmware+in+Korg+X50 ..

It is a known issue! https://www.google.com/search?q=display+problems+with+KORG+D1200 ..

Give your email, I'll send for free.

The buttons are damaged or defective. Replacement may be the only answer.