Top 20
Northgate (walamd240a) PC Desktop Questions & Answers
I have a northgate WALAMD200A, the power went down
Unplug it and wait a bit, then retry.
If it fails again:
-an internal fan might be stuck, causing the thing to shut down out of caution
-the BIOS battery might have given up the ghost
-a chipset heatsink might have fallen off and need some care
-the power supply might be toast (swap for a good spare of adequate wattage and retry)
-maybe your videocard just got unseated because of cable buggering, just set it back
11/11/2009 12:41:01 AM •
Northgate...
•
93 views • 0 helpful votes
Casx02017r
Try changing the CMOS battery, and see if the problems go away.
6/13/2014 6:57:34 PM •
Northgate...
•
31 views • 0 helpful votes
Sparks from back of computer
Please don't turn it back on. Unplug your computer from the wall and examine the wall socket for blackened or burned sections. It is likely that dust has caused a short in your computer. Sadly, most times this means that you are going to need a new computer or at the very least, some new parts. Take it to a reputable computer repair shop near you and have them test the power supply and other components to see what is salvageable of your computer. With any luck, your hard drive contents MAY have survived but there is no guarantee.
3/25/2014 12:12:29 PM •
Northgate...
•
37 views • 0 helpful votes
40drhol can I erase and reuse a good hardrive, I have the recovery cd and the otherboard cd. hanks Rich
"40drhol"? If you are re-installing the OS, when you re-install it will ask if you want to format. If the HDD is not the Primary HDD in your computer. a spare HDD, If the HDD is compatible with your computer interface you can install as a slave/second/primary, depending on the interface/pin outs, or load a different OS on it if you wish and have a Dual-Boot. If it's a second drive in your computer, Open Start Menu, Computer, Select the HDD, just right click and format ,select File System.
2/14/2013 11:28:41 PM •
Northgate...
•
52 views • 1 helpful votes
Connecting hp photo smart 7350 printer to northgate computer
Hello,You need to install the driver of your printer that works with the operating system of your northgate computer. The driver is in the CD/DVD that came with your printer. After installing everything, you can add RadarSync to your computer to optimize your computer's driver (eg. keeping them updated to avoid from some problems, and running automatic updates so that you can avoid from the headaches of doing the updates manually). I hope this helps.If you need more info, please let me know.Carlo
1/23/2013 12:29:13 AM •
Northgate...
•
57 views • 0 helpful votes
No Sound on Nothgage I-1
You may have to use the XP drivers . there may not be drivers developed yet for the Windows 7.
The manufacturer is the one who supplies compatible drivers to run with the operating system.
6/21/2011 10:15:43 PM •
Northgate...
•
43 views • 0 helpful votes
I need the sound drivers
Go to the control panel and find the system folder then find the device manager then find your sound card and you can load the driver from there. Also make sure your sound is not muted.
4/20/2011 1:05:59 AM •
Northgate...
•
45 views • 0 helpful votes
I have a northgate protek
During the boot process you will see on the screen to press delete to enter setup
Press and hold delete during the boot up process to enter BIOS you can load failsafe defaults or load optimized defaults ,press escape then press f10 to save to cmos to restart then
once you have your computer running try uninstalling a few unnecessary programs then click start run type cmd then type chkdsk/r/f which will scan for and attempt to fix any bad sectors and automatically fix any corrupt files on your hard drive then defragment your hard drive then you might test all leads that are attached from your ((motherboard to your hard drive)) or just replace them there probably old and faulty
hope this helps
3/27/2011 4:48:27 AM •
Northgate...
•
77 views • 0 helpful votes
Have no sound.
Does this problem came all of a sudden? Do you hear sounds before? Check the icon with the speaker (or something like this) at the lower right end of the taskbar. Is it marked as forbidden? Click on it and enable sounds.
In case of a problem or clarification, don't hesitate to post me a reply before rejecting my answer.
If you are satisfied, rate my solution with the "thumbs" or (even better) add a testimonial.
Thanks and regards
Stelios
direct fixya link: http://www.fixya.com/users/technical114
9/9/2010 1:30:27 PM •
Northgate...
•
47 views • 0 helpful votes
I have a Northgate laptop 755110. I upgraded the
Some laptop keyboards have small "tabs" on the edge closest to the LCD screen, and those tabs fit "under" something metal,
in order to hold the keyboard in-place. Gently "work" that area, to get those tabs to move "above" (instead of "under"), to release the keyboard.
4/27/2010 6:54:59 PM •
Northgate...
•
218 views • 0 helpful votes
Power chord shows green light but computer will
First you need to check the power output of the power supply. Check the supply to tell you the output voltage and match that to the reading on a volt meter. This will give you the basic check for power.
If there is the corect voltage from the psu, keep it unplugged from the computer. Next remove the battery from the unit and hold down the power button for 10 seconds. This will clear all power from the unit and reset the power management. Plug the unit in without the battery and try to boot. Not many systems anymore require the battery to be in to boot. If this does not boot then put the battery in and give it a try.
If the unit does not boot, unplug and take a small pen and see if the power socket moves at all. If it does, it needs to be resoldered or replaced if the center pin (if one exists) moves on its own.
If the system turns on with or without the battery just for a moment then goes off, there is mostlikely a problem with the psu not having the ability to work under load. what this means is that the psu can output the correct voltage but once a load (the pc) is applied, the psu does out. This means the transformer it bad and you need a new power cord.
Without the model of the computer, this is what can be done without a service person physically looking at it.
2/1/2010 2:39:37 PM •
Northgate...
•
114 views • 1 helpful votes
Laptop cuts off during operation and when I
Hi
Thank you for your query
Please do the following steps to narrow the problem down
1) Switch on the laptop
2) Once switched there may be a meeage that says press del or F12 to enter setup, if not try the del key or F12
3) This will being you into the bios screen, once in there let the laptop run, if the laptop keeps cutting out in tis mode, you will have a overheating issue
If it is overheating then try cleaning out the vent where the hot air comes out from, if that doesnt looked block then it looks like the Heat sink (the fan that cools the CPU down) is faulty and will need to replaced.
If however it does not cut out then you have a sftware issue and i would recommned a clean install
Hope this helps
If this has been useful please leave positive feedback/vote
2/12/2010 5:04:20 PM •
Northgate...
•
80 views • 1 helpful votes
I have to do a
some computer have a partition set aside for back up. but without the disk it is near impossible to access them.
10/21/2008 10:10:15 PM •
Northgate...
•
68 views • 0 helpful votes
A person has locked my
Sounds like someone tapered with your computer while you weren't looking lol
You may need to perform a system restore to get control back.
You can restore the system by placing your windows CD in the CDROM drive normaly drive D:
Restart the computer
Go to your BIOS
Make sure the boot sequence is set to
1st Boot Device - CDROM D:
2nd Boot Device - Primary HardDrive C:
3ed Boot Device - Floppy A:
Or CDROM,C,A
then save and exit
restart the computer
you should see ( Windows is now starting your computer )
and the install process will begin.
once windows is installed and you've put your key in
you should go to the windows update site to download ALL critical updates and service packs
Then you'll want to load driver software for your computer,
Az
9/15/2008 7:56:31 PM •
Northgate...
•
64 views • 0 helpful votes
My monitor for my Northgate
Most any monitor should work on your system. The only real limitations are the display capability of your video card. Most video cards will display up to a 22 inch monitor without any problem. Here are a couple suggestions
http://www.newegg.com/Product/Product.aspx?Item=N82E16824001268&cm_sp=DailyDeal-_-24-001-268-_-Homepage
http://www.newegg.com/Store/Category.aspx?Category=19&name=Monitors
7/16/2008 11:31:43 AM •
Northgate...
•
269 views • 0 helpful votes
Not finding what you are looking for?