20 Most Recent RCA 32F531T 32" TV - Page 6 Questions & Answers

Sounds like the flyback. Mine did the same. I am in the process of trying to fix it. Try techlore.com for more help.

central processing unit,cpu are all driver of tv like sound,picture,switches malfunction and etc.

the cpu of your tv is not working,coldsolder the mainboard of your tv and the cpu then get the voltage output of your tv.

the power supply of your tv is not working,coldsolder the mainboard of your tv,

go to menu settings and find the unlock code of your tv,if not working buy new original remote of your tv

press menu button on front panel and volume down on remote for 3-5 sec.

Get an ESR meter and check all the electrolytic capacitors in the set! I am sure you will find many decoupler and coupling capacitors that are on the edge or too high in ESR.

Jerry G.

your horzontal scannig it not fired up to run the set and produce secondary voltage supplies like video,brightness etc.cal for service possible horizontal out put transistor or flyback .

the set has a fault ,requires service befor it gets worse.

Time to go to BEST BUY and nuy a better tv

Source box problem......nothing wrong with TV............T.

How old is this TV?
Sounds like it has high voltage failure.
(If you hold your hand on the screen when you try and turn it on, do you feel the static? )
Unless the set is over 10 years old, I would overhaul the high voltage circuit. Should cost under $200 at a shop.

do a set up and turn off sap in the audio setup.auto program again

invest in a service call,you tried .

does the set turn on or just buzz.

the loc code is 000 finish and save settings and exit /st.

you must repair the remote to solve the fix.if you can get into the menu turn off front panel lockout

it sounds like your convergence alignment has shifted or you can adjust the screen and focus controls to see if they respond,if the colors or haze gets better or worse with the screen and focus adjustments ,loook at a cap in the screen circuit it should be 10mfd 250v cap the feeds the neck board,

wiil get back to you.

Examine horiz circuit with magnifier.....look for bad solder
connection.............check power supply area and solder pins of
horiz output transformer.............T.