20 Most Recent Samsung DLP HL-P5663W 56" TV - Page 6 Questions & Answers

Fault with main board. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/

Fault with main board. Shorted component/s. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/

Set-up (Programming) procedure is too much to type in here, and is not practical and it will differ brand-to-brand remote controls.If you wish to get more; check the site linked here. It has set-up code list & set-up procedure to many popular brand remote controls. Pull up older posts. http://electrohelponline.blogspot.com/ http://remotesearch.blogspot.com/

Check the orientation of the antenna. Try to rotate it, and see whether the signal strength varies. If the signal strength is too weak, digital channels will show many problems. Try a signal booster. Contact any service technician. http://electronicshelponline.blogspot.com/

could be failing - or speaker / amp inside is worn out - time to replace or if it has rca outputs y or headphone socket you may be able to use a soundbar or amp to increase sound via external sheiled speakers

just reverse the yoke connection

Do you have a voltage meter tester to make sure that the lamp receives voltage?

What is the difference between component av cable and composite av cable On the five wire cable, the red, blue and green are for the picture. The other two connectore are for the audio. Not all TV's have this type of input. The link above has information about the five wire and other input cables.

Your bulb needs time to warm up, soon you might need to replace it.

the signal given to the tv will not be proper

The problem is with the ckt that controls the manual keys on the TV.Disconnect it and the rest should work with your remote.

Sounds like corrupted software. A firmware update must make it right. Contact any service technician. If you wish to get some details; check the site linked here. Viewing it in "Mosaic" or "Magazine" will make surf easy Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/

I am having the same problem

it mite be your power button that needs to be replaced

you just have to replace the lamp so take it out see what model it is an buy a new one

have you had to fry pals the lamp in it. if so the do mite be lulus so try to put it on titer