20 Most Recent NordicTrack 5600R Treadmill Front Roller - Page 4 Questions & Answers

The owner's manual has figures and descriptions for adjusting these rollers. The trick is knowing which way to turn the adjusting screw which may take some trial-and-error to see which way the belt is sliding after an adjustment.

Without insulting you, I assume that you have waited long enough for the incline calibration to complete (while standing on the treadmill, say one or two minutes). I also assume that you would agree that moving the machine has somehow caused it to malfunction. Check that the new location is reasonably level and that all four "feet" touch and rest on the floor. If nothing remedies, it may be time to call a technician.

I recommend you talk to a Nordic Track service representative or technician. I am guessing that the motor that raises or lowers the incline is broken of malfunctioning. Our representative never told us the consequences are if the intermittent, routine diagnostics the machine runs do not complete or "freeze" up.

This seems abnormal. These machines seem to have an intermittent diagnostic that they run which includes (or simply consists of) raising and then lowering the incline or slope. If this process seems to hang or the machine never returns to "normal life", you may have to call your service number.

Our Nordic Track machine intermittently runs its own diagnostic when you turn the machine on after it has been powered off. This includes the first time you take it out of the box. If you notice that the display screen is on but none of the function buttons work, listen for a humming sound at the base of the machine where the motor is housed. A tell-tail sign is that the motor that slopes the running track is raising or lowering the slope (as part of its diagnostic check) which is difficult to recognize when the track is not running. After perhaps one or two minutes, the button functions return and the machine "comes alive". If not, then you'll want to locate the Nordic Track service number and talk to a technician or representative.

I did not do this!!!!!,??????????????????????????????????????????????????

If you wish to get some details; visit the site linked here. Pull up older posts.... http://electro-medical.blogspot.com/

hi, the running belt is a little loose you have to fasten it you have two screws from behind two sides you should use special hex driver key and turn the screw clockwise only one turn for the two screws so the belt will be tight again

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electro-medical.blogspot.com/

Throw it in the trash and buy a real treadmill.

It’s your motor. If you’re the original owner the motor has a warranty.

if it's the walking belt, make sure that the rear roller is parallel to the back of the walking board. Sounds goofy, stand on the mill looking back away from the front of the display. Look down to where the walking belt goes around the roller, the roller should be parallel to the walking board.

How to Replace an Elliptical Console Please see the video, and follow the steps. However clean very well the spring with electronic cleaner contacts, and see if the wires are o.k or loose or desolder and repair. Use ALKALINES batteries for Heavy duty. Blessing. [email protected] cell+whatsAPP:+50588611441