Top 20
Janome Memory Craft MC300E Embroidery-Only Machine By The Each - Page 7 Questions & Answers
My Janome My Lock 204D was serging great last week,set it up today & it works for about 2 inches then stops & threads are all bunched up! I've changed the needle,rethreaded to no avail! What's up??
Your description made me think you have a tension problem and one review on the website reinforces it - see below.
It works but it takes awhile to get it to!
4 years ago
I received the Janome MyLock serger as a gift four years ago. It still runs fine, I haven't had to have it repaired and it still looks brand new, after fairly regular use a few times a month. The main problem I have with it is that I have to fix the tension on at least one of the threads EVERY time I sew with it. It doesn't matter if it's just been sitting covered on my desk, I have to fiddle with the tension every time I sit down to sew. I know that sergers are infamous for being hard to thread, but this one is the hardest one to thread I have ever come across! It's nearly impossible to get one of the threads through without having to stick a needle into the tight space and wiggle the thread through. It also was supposedly "ready to sew" the first time it was used; that was a joke, it took me months to finally have time and learn how to use it and it wasn't threaded right so I had to redo it. When you finally do get it threaded and the tension right, it runs like a champ and does a great even stitch!Less
icecreammom ยท Reviewed on
viewpoints.com
I have a janome memory craft 350E, when I embroider it is pulling the bobbin thread through to the right side, I have changed the tension but it is still doing it. Can you help please
I suspect the bobbin thread has escaped its tension spring. If you give the bobbin thread a quick short tug and the bobbin spool spins then likely the thread is not behind the tension spring. This usually causes hook jam but not always.
First be sure you have threaded per machine instructions... see below.
Next turn handwheel and position needle at the high point of stroke (always when loading bobbin). Remove and re-insert bobbin. Now, to be sure the bobbin thread is fully positioned behind the tension spring, before you move the bobbin thread into the notch, place your right index finger on top of the bobbin spool to prevent the bobbin spool from turning. Hold thread snugly (in slight tension) as you move it towards the back of the notch. You should feel the thread slide in place behind the spring. Let loose the spool and lightly pull thread. Note the resulting change in tension. (don't forget to set top thread tension back to a more normal setting)
Comment here if you require further assistance.
If you need... your manual may be downloaded at no charge from the Janome site.
https://www.janome.com/siteassets/support/manuals/embroidery-models/inst-book-mc350e.pdf
Not finding what you are looking for?