Top 20
Samsung HLN5065W 50" Rear Projection HDTV-Ready Television Questions & Answers
My samsung SP47W3HFX just goes off and comes on again alone
The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.
Search the site by type in the "brand name" to your device; [Exclude the model number], in the "Search box at the top right of the display window of the Homepage" to get gathered related posts.
Green lines in TV
Take the TV cabinet apart and unplug and replug all the circuit board connectors, that may fix the issue.
Samsung HLN5065W
Those blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://homenol.blogspot.com/
http://electronicshelponline.blogspot.com/
If blinks continue without any pause, the main board is faulty.
It is making a humming noise
Rear projection TV's have fans that can become noisy with age also the colour wheel motor also can become noisy. Replacing the fans should be easy and cheap, the colour wheel motor not so much.
Pixels break up
Are you sure this is not a signal issue? Sounds like one to me...
Replacing ballast
Hello,
You would need to test the voltage coming to the ballast which depending on the ballast should be at least 320V but nothing higher than 370V maybe even 380V? (if someone know the exact please post)
CAUTION DO NOT TEST THE POWER GOING FROM BALLAST TO THE LAMP ITSELF (the ignition charge is too much ~15kV)
I assume you tried a new original Philips lamp and that you replaced the lamp door cover correctly.
Is this tv bluray compatable
This model will project blu rays at a 720 resolution, since I cannot find if it had a HDMI input you might need a HDMI to DVI converter easily found at radioshack or online! This so you can get a greater picture!
Hope this helps!
Focus on samsung rear projection tv
Adjust focus is really a skilled work indeed. If you wish to get more details, check
this site.
Pull up older posts there. Check the site with patience, as it has over
2250 posts now. All are related to
electronic equipment repair help.
HLN5065W not recognizing dish network
Hi Judy, my name is Mike Houston a Social Media Representative at DISH. I see there is a problem with the Samsung not recognizing the DISH equipment. I am happy to help you today with this issue. Are you not getting a picture or message on the screen? What type of receiver are you using, SD/HD? I will provide you my e-mail and you can contact me directly: [email protected]
Samsung HLN5065W replaced the lamp. Tv wont stay on.
When your TV turns off without any reason, there are a number of possible causes. The problem could be a loose connection, a sleep timer that's been activated accidentally, or even a buildup of dust on the circuit board that causes overheating. To help you better determine what the problem and solution might be, follow the simple troubleshooting steps in the article
TV turns off. I hope this helps!
Not finding what you are looking for?