20 Most Recent Pioneer XM CD REMOTE MOSFET50 EEQ Questions & Answers

If your Pioneer has a cassette deck the simple solution is to use a CD adapter for cassette. These can be purchased from Amazon from about 1 pound. Works perfectly for me. ANDO

1. Press and HOLD the source button till the radio shuts off. (
2. Press and hold the FUNCTION button until the display pops up, then release. (If you do not have a function button, then push the AUDIO button)
3. Press the FUNCTION button again until the clock shows on the display.
4. Press the UP and DOWN buttons to adjust the hours.
5. Press the LEFT or RIGHT arrows to MOVE TO THE MINUTES.
6. Press the UP and DOWN buttons to move the minutes.
7. When complete, press the source button to exit.

Hopefully this will help you out.
Constant 12V+
Blue/Yellow Switched 12V+ Gray Ground Brown Illumination Green Dimmer n/a Antenna Driver's Pillar Front Speakers 4" Dash Left Front (+) Pink Left Front (-) Purple Right Front (+) Green Right Front (-) Blue Rear Speakers 5 1/4" Rear Deck Left Rear (+) Black Left Rear (-) Yellow Right Rear (+) Red Right Rear (-) White

hold the src button on the unit till its off then hold the function button down to go into the initial setup menu where you will find your clock adjustment

The Aux works when you have the RCA jacks from a DVD player or video game connected to the back of the stereo. When in that mode, the stereo will play the volume from that device.

This happens when it cannot read a disc. I usually only run into that on mine when it's extremely cold out in the winter. The player may be shot, is it old?

aux stands for auxiliary input, it means a device like mp3 player can be plugged into head unit and passed along and amplified by the internals of the radio. so the radio will control the passive device.

unless you have a headphone jack or rca input in the back
i really dont know the deck but thats the 2 easy ways

Didn't fix it - but am not spending money when it said FREE help!

try turning off the radio then press the clock button then press for 3 seconds the function button this will give you access to the clock functions.

you will need to turn unit off then press function button for a few seconds this will take you to the clock function.