20 Most Recent Ryobi Drill Press: Drill. 10 in. DP102L - Page 7 Questions & Answers

check charger operation if ok , junk the batteries

Problem?

Hi P117 charger green ::::: fuse is inside remove 4 screws on back, Cheers

One issue with LiOn batteries is that if they get completely dried out they become useless so charger wont charge them. drillselect com

No fixya has no parts for anything go to a tool supply shop or wood working shop

home depot -lowes -most hardware stores--go online to buy the replacement for repair do a search for tool repair store in your area but might be cheaper to do replacement

Make it dry in direct sunlight after well dry then you can try to connect with charger

try e-bay enter brushes for ryobi electrical equipment

usually with such devices, the answer is yes

If the old charger has a deep-uncharge-protection contact and was also made for Li-ION ther is in any case a marketing technical design by a notch to protect the battery to place on the charger if this cells are not correct. (this answer applies to all brands with a quality mark)

Hi Alice: Is this a "key"? If so, put it in place with the drill pointing up and the key handle pointing level and towards you. A light tap with a hammer on the key handle should loosen it. If it is a "manual grip", try putting the drill in reverse, and at low speed. Hold the drill handle with your right hand, and hold the grip firmly (really firmly) with your left hand, and squeeze the trigger. It should release the chuck. If it doesn't, try putting a pipe wrench on the grip.... gun facing away from you, wrench from the top, handle on right. gently tap on the wrench handle should loosen it. Cheers.

check if battery is good check if bulb not busted