Top 20
Epiphone Sheraton II Guitar Electric Hollowbody Questions & Answers
Tone knob and switch info
the switch, has three positions. Typically forward or up will be your neck (or rythm) pick ups, only and will work with one volume knob(usually top right as your looking at guitar), and one tone knob ( top left as your looking at the guitar). when the switch is in the far right or all the way down position, that will be the saddle (or lead) pick-ups. And that works with only one volume knob(bottom right as your looking at the guitar) and the corresponding tone knob. when the switch is in the middle position, botjh volume knobs work and both tone knobs work. You've gotta kinda play around with them to find whatever sound yopur looking for. and tone knobs are very subtle in their changes. good luck
8/26/2014 6:47:07 PM •
Epiphone...
•
209 views • 0 helpful votes
How do you get to the wiring?
Sounds like the toggle switch needs to be replaced. If unfamiliar with the procedure, take it to a repair shop.
6/29/2012 5:42:29 PM •
Epiphone...
•
79 views • 0 helpful votes
I am looking for a manual (if there is one) for
Most likely it is wired like most Gibsons. The volume knobs are the two at the neck end, the tones are the two nearest the rear. The lower two are volume and tone for the bridge pickup, the upper two are for neck pickup. Switch down is bridge or lead pickup, switch up is for neck or rythym pickup, and centre position is both pickups one, where all knobs can be used together.
3/4/2011 8:04:48 PM •
Epiphone...
•
1,147 views • 4 helpful votes
Bass strings are too loud
Adjust this using the EQ on the amp and to a lesser extent the tone controls on the guitar.
Often people boost the bass way up causing this problem.
2/12/2011 10:51:31 AM •
Epiphone...
•
216 views • 0 helpful votes
Epiphone EJ 200 CE/AN Electro Acoustic Guitar Wiring Diagram
Does this guitar have a esonic 2 system, if so the other pickup is piezo pickup located under the saddle, there should be two wires coming from the pre-amp just remove the pre-amp from the body and make sure that the two wires are still plugged in and attached to the pickups, these are plugs like a small headphone style plug, just check these and the wires are held in by small wire clips,one of the wires may have came out of the clips...hope this helps I will look for a schematic for you and post it if I find one...Good Luck!!!
Not finding what you are looking for?