20 Most Recent Sharp Notevision PG-A10X Multimedia Projector Questions & Answers

http://www.google.co.uk/search?q=81es1822

Could be anything.

hi,
do the fallowing setup and try again.
ok

p { margin-bottom: 0.21cm; }

If you forget the password, delete it using the fol-

lowing procedure and set a new password.

p { margin-bottom: 0.21cm; }

1 You can only use the buttons on the projector

to delete the password.

2.The password cannot be deleted using the

above described procedures while the "Anti-

Theft" function is set. If you forget your pass-

word while the "Anti-Theft" function is activated,

u have not mentioned how long u have been using this projector. either the lamp life is low or the circuitry protecting the lamp temperature is defective or even the air intake of the fan is inadequate, a filter is fitted for air flow if this is clogged or blocked, lamp temp will rise and unit shuts down. if lamp indicator is yellow or red it is time to change the lamp. if it is red - lamp is totally out, if u turn on the unit four times without replacing lamp, the unit simply wont turn on. one other possibility is power cable and power connections. check power cable too. 

you need to reset the lamp timer. hold down the enter, down, and menu, then press power.

Yes you need to replace lamp,so you buy a new lamp.

Hoi.

Het is waarschijnlijk een input probleem.

Controleer kabels en probeer met behulp van verschillende kabel.

Als dat niet repareren, dan is de audio-video op circuit, of de digitale video-circuit is defect.

Groeten.

Hi.

It is probably an input problem.

Check cables and try using different cable.

If that does not fix the problem, then the audio video on circuit, or the digital video circuit is defective.

I cannot type in Dutch, but I can read you.

I re-typed this text in German and translated into Dutch using google. The result looks readable.

Regards.

Main line fuse is on the board where the ac cord plugs.
The caps in the power supply usually leak and explode after 5 years, blowing the fuse. Solution is to replace the power supply and lamp ballast boards. Expensive repair.

check the power supply heard issues with this system like that but was all related to the power supply

Does the temp. light come when it switches off ?

Check if all the fans are running when switched on.

If all the fans are running - take out the lamp and check if you can see any irregularity on the shaft of the lamp's insides.

If not then you will most probably have the Ballast ( Lamp's powersupply ) replaced or repaired

https://www.fixya.com/support/t14696300-reset_change_counter_sharp_ar_5726

Question edited for clarity, turned around, added CAPS, added the word 'manual'.Duplicate question should have been deleted but Kardoc has answered, albeit wrong model. Refresh page to see your question when you press 'Post Question'.UX-105 in Russian, or 510 in English, which is probably close enough.https://www.google.com/search?q=sharp+ux-105+manual..

https://www.manualslib.com/products/Sharp-Ux-510-641495.html

Question edited for clarity. Remove the curl out of the paper by running 6" across the edge of a desk against the curl. With scissors, cut the end 1/2" straight. Then cut a 1/2" off both corners at 45 degrees. Push the paper in the slot and press the Feed Button. https://www.google.com/search?q=Sharp+EL-1197PIII.+How+to+load+paper My instructions are better than the video, but shows the process well. ..