20 Most Recent
Hitachi 51F510 51" Rear Projection HDTV-Ready Television - Page 4 Questions & Answers
Got no picture
The fault can be many but it is in the main board that the fault has come about.
check for power, fault in the convergence IC or failrue of the drivers.check if there is capacitors that have leaked/weakened or shorted.
A good test must be done only if you are familiar with electronics other wise do not tamper the board.
Check the fuses or any open resistors to the board
Hitachi 51F710A has no sound only picture
Unfortunately I think you are going to have to give a repair tech a
call....................or
you can run your audio thur a A/V Receiver and by-pass your 51F710A
speakers altogether
I have not used the speakers on my TV's in over 10 years
The color is gone.
Hi
Thanks for using FixYa. From what you have described it seems that you have to
replace the convergence IC and check power resistor for leakage, if values are
not exact you have to replace them. The typical cost to get this fixed by a pro
is about $300 - and it doesn't mean that he/they will do a job better than you
do. The parts are less than $100 (about $20-$30 for the IC's) if you want to do
it yourself. Replacing only the IC's MAY solve the problem; however, many
people have also had blown resistors requiring replacement. Why would you ask
should you replace both of the IC's if only one is shot?! If one is shot the
other one is not far away and for that little price of the chips it worth
changing them both at the same time. Also the convergence board should be
checked for cracked solder. If you replace the ICs and the resistors are shot,
the ICs may blow again almost immediately, meaning you may have to do the
repair twice.
Please do accept the solution if the issue is
resolved or else revert for further assistance.
Thanks
Rylee
NO PICTURE
hitachi is known for bad solder connections on plug connectors between the two main big boards
I am unable to get
Need to press PIP button on TV remote or go to TV menu and turn off PIP feature.
Thanks.
THE SCREEN WAS TURNING GREEN THEN IT WONT P0WER UP
If the TV comes on but the screen wont, try pressing
- Press Menu on remote
- Press Select (Defaults to video)
- Arrow down 9 times (Reset Video Settings)
- Press Select twice (I think) or you may have to Arrow down and Press Select.
Otherwise, contact Hitachi support @
1-800-HITACHI
Email us at:
[email protected]
Power light comes on then goes off will not stay on
they r known 4 shady processer boards not hard to solve call pts electronics give model #will send u new board around 120$ not diffucult to instal must discharge cicutrt then ground install new board or may short micr precesses
Not finding what you are looking for?