Top 20 Karbonn Cell Ranger STIX 12V Cell Phone Booster Questions & Answers

It obviously works, so it is NOT a fuse. The most likely cause is a poor antenna connection. This happens often. Unscrew the antenna. Use a continuity meter to check check each connector. Such as the one that screws into the radio, if the continuity meter "beeps" the connector is "grounded" and was installed improperly. Do not use that antenna until you fix it, you could blow the transmitter by using a "grounded" connector. Test it exactly the same way without the antenna attached. If you are not used to installing connectors, you could easily go through 2-6 before you get the hang of them.

Radio... | 223 views | 1 helpful votes

You check your radio with other radio very near. If radio is hearing your transmission then it mean that your Radio Power Module not working if very near radio not listening you then your preamplifier and Power amplifier is not working, it mean your Radio Transmitter faulty, only Receiver is working, you consult with any Radio Service shop. One other thing if you have software also check Tx/Rx frequency it must be same for simplex operation.

Radio... | 26 views | 0 helpful votes

search for instruction manual

Radio... | 26 views | 0 helpful votes

It is a direct entry scanner so just enter manual and program then enter the frequencies you want. Press enter after each channel and press program again to advance to the next channel and repeat.

Radio... | 41 views | 0 helpful votes

I don't think any of the above read the original complaint. The fact is that the person above and myself both tried the 0000 and the one two three four and several other such combinations, and none of them worked. The question is, what do we do now? What is the correct pin?

Radio... | 2,121 views | 0 helpful votes

Hello Jeff, I was looking for the user manual of your CB Radio Hatadi, to know what fuse it takes and there is no information
I would try the 5 Amp, I would place it and it would work for a long time to the BC Radio, checking that the fuse resists the transmission work
If it does not resist, I would put the 10 Amp and would do the same test
If it does not resist either, then you already have problems with the equipment
If so, look for a specialized technical service
I hope you can solve the problem
Greetings Franco Dosil
Hola Jeff, estuve buscando el manual de usuario de tu CB Radio Hatadi, para saber que fusible lleva y no hay informacion
Yo probar?a con el de 5 Amp, lo colocar?a y har?a funcionar por un rato largo al BC Radio, comprobando que el fusible resista el trabajo de trasmisi?n
Si no resiste, pondr?a el de 10 Amp y har?a la misma prueba
Si tampoco resiste, entonces ya tienes problemas en el equipo
Si es as? busca un servicio t?cnico especializado
Espero Puedas resolver el problema
Saludos Franco Dosil

Radio... | 22 views | 0 helpful votes

You would have a better chance of someone being able to help you if you post of the make and model of the radio. Base, mobile etc.

Radio... | 21 views | 0 helpful votes

sounds like a bad antenna or connection to it

Radio... | 26 views | 1 helpful votes

Contact Tait directly to inquire.

Radio... | 23 views | 0 helpful votes

Raymarine Ray55 Manuals Down Load user manual and reset MMSI according instructions.

Radio... | 22 views | 0 helpful votes

Your radio have hardware problem, check 100 ohm resistance around your volume, may be its open cct. Also so if this circuit is working ,you pess squlech button and adjust volume, if you cannot adjust volume then definetly is my above written problem.

Radio... | 25 views | 1 helpful votes

Hello Larry, I have looked in the service manual of Marantz SR-1000, the circuit that makes the tuning indicator work and I found that there is one circuit for AM and another circuit for FM, which have in common, the FM selector key and A.M
My suggestion is, with Marantz unplugged from the power grid, try to clean the key with some contact cleaner and change the position of the key from FM to AM and vice versa, many times, to clean the contacts
After doing this, connect the Marantz again and check if it is tuned
I hope he manages to make the Sintonia indicator work
Greetings Franco Dosil
Hola Larry, he buscado en el manual de service de Marantz SR-1000, el circuito que hace trabajar al indicador de sintonia y encontre que hay un circuito para AM y otro circuito para FM, que tienen en comun, la llave selectora de FM y AM
Mi sugerencia es, con el Marantz desenchufado de la red electrica, que trate de limpiar la llave con algun limpiador de contactos y vaya cambiando la posicion de la llave de FM a AM y viceversa, muchas veces, para que se limpien los contactos
Despues de hacer esto, conecte nuevamente el Marantz y verifique si marca la sintonia
Espero que logre hacer funcionar al indicador de Sintonia
Saludos Franco Dosil,3b686c096e97301a310a1ea24f94fa2d/no_html,1

Radio... | 24 views | 0 helpful votes

Your Mic problem, you repair the mic or change the headset.

Radio... | 25 views | 0 helpful votes

unmark PTT id, in above condition your transmission is working good, you can check if you have other radio by listening your message.

Radio... | 22 views | 0 helpful votes

See this site, and if you want to appear you can do practice for examination.

Radio... | 19 views | 0 helpful votes

Not finding what you are looking for?
Karbonn Cell Ranger STIX 12V Cell Phone Booster Logo

0 questions posted

Ask a Question

Usually answered in minutes!

Top Karbonn Radio Communications Experts


Level 3 Expert

1655 Answers

Brad Brown

Level 3 Expert

18060 Answers

Mike Charette

Level 3 Expert

1847 Answers

Are you a Karbonn Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Karbonn Radio Communications

  • Karbonn Radio Communications

Most Popular Question

set up tx3350 cb radio monitor 2 x

  • Radio Communications