20 Most Recent Canon imageRUNNER 2270 Copier - Page 2 Questions & Answers

change the laser ppppppppppppppppppppp

you should cleaning scan and glass

Hey!Its a scanner motor error!If u can,ask a canon technician to come and have a look for u!It might just be a connector that's not in properly!Good Luck!

i have canon ir 3570 and i have error eoo0575 who can clear this error

The two problems may not be related. Adding toner should not under most circumstances cause copies to become light, unless the toner you are using is of a poor quality - I hope it is a Canon cartridge or quality generic. It sounds as though your fixing film or drum unit may need replacing, or perhaps you need to perform a install procedure. As the 'install - toner - start' option is free, try it first:

First press the head key and then the number '2' and '8' keys at the same time then press the head key again. This will take you into service mode - select 'copier' then 'install' then 'toner' then 'start'. This will run throught a cycle that takes a little while, I think about 599 seconds (sorry for been so accurate but unhelpful but that's what I remember from the display - never converted into minutes but you're welcome to).

But if you are having blurry or even dirty or light copies it may be the fixing film. When the copies are printed, immediately check if you can rub off the toner at all by rubbing the print with your fingers - if so this indicates that the fixing unit is not hot enough or there is not enough pressure - check that the fuser is in properly and that the jam release lever is not engaged.

Lastly, it could be your drum unit that is faulty or worn. Totest this you will need to try and stop the machine in the middle of printing before it reaches the fuser - open the front cover and latch down the transport bed with the green handle - remove the paper gently so as not to disturb the ink in any way and observe the image quality - if it is displaying the exact same symptoms then it is not your fuser and is probably the drum unit or dodgy toner - most likely the drum. However, if the image is fine, then it most definetely is your fuser film (and or perhaps the cleaning roller that cleans the film).

Good luck

This is the Charge Coupled Device. Its a part that would need to be replaced by a technician. There is no way to explain to you how to get to it or how you could order this part. Your local canon dealer should be able to help with this problem.

problem with your driver and uninstall the driver and reinstall the driver and second thing remember