20 Most Recent
Canon PC-940 Black and White Copier - Page 8 Questions & Answers
System resetup procedures for canon iR2016
hi you error code is referring to the fixing film in your fuser unit is not aligned, in other words its moved to one side and the sensor is detecting it as not aligned. order a new fixing film and replace it or order new fixing unit.
canon tech
EO10 CANON PC940?
E010 is a code indicating main motor failure.In actuality it rarely fails.look for a broken belt or gear in the Main Motor train.Good Luck
Toner is jam and will not come out.
Generally with a PC940 you must rotate the old toner cartridge clockwise to get it out.When you put in the new one, after pulling the tape off turn it counterclockwise to get it to work.Good Luck
The paper won't feed
Some times need to clean "paper roller" with water-based cleanser with
white fabrics or rag. The reason of this problem often is paper dust.
The paper roller have excentric shape and you must to clean biggest
radius of contact sphere of paper roller. To do this you must to
interrupt rotation of roller, then printer try to pick up paper, by
"power off" printer.
Canon np 6112 E007
An error in the rotation of the fixing film is detected.
The reading of the main thermistor is 100°C or higher and, in addition, the fixing film sensor does not detect the rotation of the film for 6 sec or more while the fixing motor is driven.
Canon ir2016 error E808
E808 0000 Fixing drive circuit failure
- The heater does not turn on.
- A fixing drive motor failure was
detected.
- Check the connector of the fixing film unit.
- Replace the fixing film unit.
- Replace the fixing drive motor.
- Replace the DC controller PCB.
- Replace the power supply PCB.
PC 940 Canon Copier help with cleaning
Hello sir; Discharge corona unit dirty it cause this problem, got to be discharge corona wire covered by tone, clean outby rubbing alcohol,it will take care your problem.
Canon PC940 Ticking noise when copying and regestration is off
The waste toner is in the drum unit it's self. If it full you may as well replace the drum unit all togather. Once it is full the drum is just about shoot. If the regestration is off, you may have a problem withe reg. feed clutch. Dose it show up with the paper tray and the manual feed try?
Pc940 faded centre
Have you replaced the drum cartridge yet? Or did you and this what you are getting. If the old drum was working ok, but dark. You may have a defective drum unit.
PC 920 Faded sides
hi
try this open the copier and remove Toner Cartridges and shake side ways for 5 times and try to make copy,if faded gone its better to replace Toner Cartridges for better copy quality
COPIER PROBLEMS
Start by powering off the device and unplugging if from the wall. Let it set about 1 min and power back on. If the jam light is still on go to the directed area and make sure that an actuator, switch or sensor is not pulled out of position or covered with paper dust or a tiny piece of paper. If all is clear and nothing out of place you could have a bad senor, switch or actuator. The worst case would be a bad board.
MY COPIER KEEP FLASHING A
the copier have a paper jam on the left side on fixing unit or on right side .
or the copier have a paper sensor that does not move.
Canon 745
hello sir
machine error code zero is the first digit when its blinking,there is another # to show? must be 2 digit,but base on your explanation you must change the exposure lamp or scanning lamp
Not finding what you are looking for?