20 Most Recent
Canon PC-940 Black and White Copier - Page 5 Questions & Answers
Canon copier 940 trouble code EO?
Odds are that you are getting a error code E000. It is saying that you have a problem with your fuser unit. You can try to unplug the copier for a short time. But you will mostly need a new fuser unit. Good Luck
Canon PC 940. replaced
the heat element is not heating up check the connections at either end of upper fuser roller. unpluging copier for 20 minites should reset the error
I have a Canon PC
Could be optics needing to be cleaned. First I would rule out the toner cartridge. If you have a spare swap it out or remove your current cartridge, turn it over and slide open the "gate" that covers the drum cyclinder. The drum should be clean all the way across it's surface. If you see toner on each end then that is where your dark sides are coming from. If the drum is clean then most likely you have dust building up on the optics mirrors. One test for this is to manually lighten the exposure control on the operation panel and then recheck your copy quality. This may cause the rest of the copy to be light but if the dark sides goes away then your optics are dirty.
Good Luck and Thank You for using Fixya.
HOW TO CHANGE THE CARTRIDGE?
Use the following steps.
1. Grasp the button on the left front side of the machine to open the top half of the copier.
2. Look for the black plastic toner cartridge on the right side.
3. Grasp a small handle on the right of the cartridge and pull it out of the copier.
4. Unpackage the new toner, pull the flexible toner seal out of the handle of the new toner cartridge.
5. Slide the new toner in place of the old and close the cover.
Instructions should also be provided with the new cartridge.
I have got a problem
Hi,
these means that the fixing film is worn out, and you need to replace it.Call service!
HOW DO I PULL THE CARTRIDGE FROM THE COPIER?
from the left side of copier is located handle, wich you need to pull to open copier ( the copier is opened in air to the right side ).
Now the question, by cartridge do yo mean on drum unit or on toner tube?
For toner you need to realese handle to detach the toner station from drum, turn the tube of toner and pull it out.
When I copy - one side of whatever I copy doesn't
make sure the copier is on level base and check the mirrors under the glass are not dirty or fogged up.. if you can assess the drum unit giver a few gentle rocks side to side and then try another copy the unit may be tilted and the toner going to one end. also there is probably a charge cleaner at the top of the unit you can pull in and out a few times.. I would look at the toner/drum side of things if it is faint on one side..
I had a paper jam. Got the paper out, but now
Some printers won't reset the jam condition until you open a specific door or cover -- even if you've gotten the jam out, they think it's still there until you open that cover. Try opening and closing all of the machines doors and access points, and even pull out the paper tray and push it back in.
If the jam condition still isn't cleared, turn the machine off and back on with the main power switch.
Copier wrinkles copies
It cuold be that paper has too much moisture or you nned to replace press roller bushings alonh with cleaner and fixing film
How to open fixing heater open
hi you shuld have a replace the heating eliment bur befor u replace or oder heaterelement just cheq thermal fuse maybe just the thermal fuse is the coz of that becous the thermal fuse is attached in series.
thanks
Not finding what you are looking for?