Top 20
LeapFrog Leapster Explorer Learning Experience Questions & Answers
Leapster explorer battries are charged but wont work when I switch it on
Try taking out the batteries and running an eraser over the contacts. One other thing plug it in with the batteries installed and try turning it on. After it comes on then unplug and see if works. Also make sure you are using the right kind of batteries. I had to use alkaline to get our to work.
7/5/2014 4:23:49 PM •
LeapFrog...
•
116 views • 0 helpful votes
Where are the batteries for the leapster
On the back there is a big silver screw. Open it and the back comes off. The batteries go there be sure you get the right ones. I believe they have to be alkaline.
6/14/2014 6:10:12 PM •
LeapFrog...
•
109 views • 0 helpful votes
The volume button doesn't work
I had same problem, just fixed it by a little hack. The volume up switch is broken.
1. Remove accessory door on bottom.
2. Remove all screws on back.
3. Open back cover.
Looking at the exposed board, there are 2 volume switches (back to back). Directly next the switches are four contacts: the upper 2 are for volume down, the lower 2 are for volume up.
4. Place the battery pack on the board and hold it down.
5. Press the power button to turn on the unit.
6. Use a small wire to jump the volume up contacts multiple times to change the volume to maximum (or desired level).
7. (Optional) Remove the volume buttons and throw away the rubber cushions to prevent the volume from changing.
8. Replace everything back in place.
3/17/2011 2:36:31 AM •
LeapFrog...
•
3,040 views • 18 helpful votes
The speaker has blown out
Call 1-800-701-5327 for Leapfrog Customer Support. They may be able to send you a replacement part.
6/2/2011 12:43:53 AM •
LeapFrog...
•
301 views • 0 helpful votes
The screen on the Explorer
If the unit is frozen the first thing I would recommend is removing the batteries and see if its ok when you reinsert them.
1/28/2011 1:41:10 PM •
LeapFrog...
•
1,585 views • 1 helpful votes
Leap reader won't turn on
the pen wouldn't launch from app on the desktop or turn on manually for me either, You need to launch it through their website, it's a rollover button top right on the website page 'Launch Leapfrog Connect' the pen then auto turns itself on!
12/26/2013 3:07:19 AM •
LeapFrog Toys
•
21,297 views • 6 helpful votes
Leapreader won't turn off
Try pressing the on/off button to turn it off. I had a same problem. I depressed the on/off button for ~6 second or so and the device turned off. When I turned on again, the LeapReader no longer had a white light and was recognized by my computer.
2/1/2014 5:47:02 PM •
LeapFrog Toys
•
2,286 views • 0 helpful votes
Leapfrog ipad ultra black screen white dot
During a normal shut down, the screen image on a LeapPad will reduce to a white dot, which will disappear in five to ten seconds.
In rare circumstances, the white dot will not disappear and the LeapPad will not fully power down. If the LeapPad does not complete the shutdown process and the white dot remains on the screen for more than ten seconds, complete the shut down by pressing and holding the power button on the LeapPad for ten seconds. This will fully power the LeapPad down, and it will start up normally next time you power it on. For more information contact essay writing service reviews
Essaypaperreviews com Best Writing Services Reviews online
12/27/2013 5:06:31 PM •
LeapFrog Toys
•
826 views • 0 helpful votes
Low battery indicator
Have the battery checked first as it may not be connected properly or may be no good and not accepting a charge IF you run the machine off the adaptor it probably will not be charging the battery so I suggest you plug in the adaptor and leave the machine off for a few hours to see if the battery will charge.
6/4/2013 6:58:37 AM •
LeapFrog Toys
•
207 views • 0 helpful votes
Not finding what you are looking for?