20 Most Recent KLH ASW10-125C Subwoofer - Page 4 Questions & Answers

Without knowing what they're hooked up too.. SOUNDS like your uder powering them, OR over powering them. Look at the back of the speakers the wattage is what your looking for, look at your amp, example: 1000w speaker running on 50w amp = not good.

Still need a proper design so you don't blow anything but yes you can.

Go to manufacturer website and download.

Please refer to user guide specs about your Turntable for the Output type That is MM or MC (Moving Magnet or Moving Coil) then on the receiver look for PHONO input and interconnect

http://www.audiocircuit.com/Home-Audio/KLH/CDR-1000

Wrap a wire around the outside Metal of your rca jack in back of your radio and ground the other end of that wire to the back of your radio and the noise goes away

Yes, the 10-120 can use a L & R low level subwoofer input. You can get a short 6" RCA splitter adapter from Radio Shack for a under $10. (1 female input, 2 male outputs) Alternately, just plug the subwoofer output on your receiver to just the low level R channel on the KLH sub.

Hope this helps. http://www.d-s-t.com.au/data/Misc/S100ETH-Instructions.pdf

Most likely the amp in the sub has blown. It will need repair or replacement. I'd take it to an expert in repairing amps, it's not a job for you unless you're experienced in troubleshooting these things.

at every online electronic store

Wire what exactly. Which set of KLH speakers have you got?