Top 20
SkyScan 86742 Digital Atomic Wall Clock Questions & Answers
I have eight atomic clocks,none of them have the outside temperature working,all have new batteries???
If your outside temperature is not showing on your clock, that may mean that the clock and the transmitter have lost their connection. To reconnect them you must first take the batteries out of both of the units for 15 minutes. First put the batteries back into the transmitter, and then the clock. Let them sit side by side inside your home. When both the indoor and outdoor temperatures show on your clock with the same reading, or within two degrees of each other, then you may put your transmitter back outside. Remember to keep the transmitter out of the direct sun in a dry place. Also keep it away from metal, which can affect the readings.
Hi, I have an atomic clock, and the numbers are
I assume you mean the LED Display unit..... If that is starting to go..... you need to buy a NEW ONE.,...... unless you are really good with a Soldering Iron and also know Electronics.... and then getting the Wiring Diagram will be a Major Problem
Please help me turn off the alarm
On my similar model, there are 4 buttons on the back. The 3rd button starting at the left is labeled ALM. You should be able to turn the alarm off by pressing that button.
Looses time
Clock shouldn't lose time if it is receiving time signal. Do you have the signal indicator showing?If not suggest you take the batteries out and reset the clock, making sure that you do not set a time.
Manual for SkyScan atomic clock -model 86742
I
Hello
The SkyScan ATOMIC Clock
With the Skyscan Atomic Clock, you have the most accurate timepiece within the continent. It can receive the time signal transmitted by the National Institute of Standards and Technology (NIST), which is regulated by 3 atomic clocks and deviates less than 1 second within 3,000 years. The NIST broadcasts the time signal (WWVB, 60kHz) continuously from Fort Collins, Colorado. This signal can be received anywhere in the continental USA that long wave (AM) radio reception is possible with a portable radio. It is expected that the signal can cover a distance of over 2,000 miles from the transmitter. Therefore, your clock will receive the signal within the broadcast range anywhere an AM signal can be received; generally the signal cannot be picked up in massive metal and concrete structures unless near a window. In addition, some environmental effects (see next page) may affect the transmitting distance.
Directions to set up clock
Hellohttp://www.atomicclocksstore.com/Get into this link. You can download the user manaul for your clock from here. Get a serach over the site.
After changing batteries in both
I have a thermometer with an outside sensor. It's necessary to remove both batteries, wait a few minutes, then replace batteries - sensor first. It may take a few minutes for the inside clock to pick up the signal. If it doesn't, try again with new batteries.
I have a SPC900 sharp
I have a brand new Sharp Atomic Clock Model SPC900 and have gone thru the initial setup guide... I chose to allow the transmitter in Ft Collins, Colorado to set my Time and Calendar automatically however it has yet to set my clock after two hours now...Please help...
Tony
I have an acurite atomic
I had one of these a while back and it had a required sequence for putting in the batteries. When the signal dies and you have to replace the transmitter batteries and the clock batteries in a certain sequence. The transmitter batteries cannot just be replaced. You also had to remove the clock batteries, then put in the transmitter batteries, then replace the clock batteries.
Not finding what you are looking for?