1. Check the control panel to
see which color of toner is empty. As an example, the procedure for
replacing the cyan toner cartridge is described below.
I
f the Auto Toner Replace
check box of Mode Setting in the Status Display was selected,
printing stops when the toner is empty, and the empty toner
cartridge moves so that it can be replaced. .
2. Press the Rotate Toner
key. The lit indicator for the cyan toner goes off, and then the
toner cartridge carousel rotates. When the cyan toner cartridge is
positioned so that it can be replaced, the indicator for the cyan
toner lights up again.
Press the Rotate Toner key
once to move the cyan toner cartridge so that it can be replaced.
With each additional press of the Rotate Toner key, the black,
yellow, then magenta toner cartridge moves so that they can be
replaced. The indicator for the toner cartridge that was moved so
that it can be replaced lights up. Installation:
Pull the lever, and then
open the top cover.
If there is paper in the
output tray, remove it, and then fold up the output tray before
opening the top cover.
Do not touch the transfer
belt.
2. Carefully pull out the
drum cartridge.
Dispose of the used drum
cartridge according to your local regulations. Do not burn the drum
cartridge.
3. Prepare the new drum
cartridge.
Do not touch the PC drum on
the drum cartridge.
4. Install the new drum
cartridge.
5. Carefully close the top
cover.
The printer must complete a
calibration cycle (less than 2 minutes) after the drum cartridge
has been replaced. If you open a cover before the printer is reset,
the calibration stops, then starts over again after the cover is
closed.
Also try:
1. Double-click the magicolor 2400W Status Display icon in the
System tray,
ORgo to Start/Programs/KONICA MINOLTA magicolor 2400W
Utilities and select KONICA MINOLTA magicolor 2400W Status.
2. In the resulting dialog box, select Printer from the menu
bar, then select Mode Setting from the drop-down.
3. You will then be allowed to change the state of the Toner
Empty Mode.
magicolor
1. Panel should say READY.
2. Press MENU/SELECT button.
3. Press Right arrow button until you see ENGINE.
4. Press MENU/SELECT button.
5. Press Right arrow button until you see TONER EMPTY.
6. Press MENU/SELECT button.
7. Press Right arrow button until you see the desired state for
the action when toner is empty.
8. Press MENU/SELECT button.
9. Press Up arrow until you see READY.
271 questions posted
Usually answered in minutes!
321 Questions
259 Questions
182 Questions
115 Questions
97 Questions