20 Most Recent
OKI C3200n Led Printer - Page 3 Questions & Answers
My printer is saying paper jam, but I can't find
Have you opened up the top cover, removed all the cartridges etc?
Also paper can get stuck in the front door.
The sensor in the front door behind the manual feeder can get stuck down in the wrong position.
MacBook Pro will not recognize drivers for OKI C3200N
Sir,
Go to (Start > Control Panel > Hardware and Sound >
Add a device) Check for connected devices. You can also go to (Start >
Control Panel > Hardware and Sound > Add Printer > Local) check the
USB1, 2, 3 options is available for using an existing port. The options are
LPT1, 2, 3 (Printer Port)
| COM1, 2, 3, 4 (Serial Port)
| FILE (Print to File) | TPVM (Thin Print) | XPSPort. Select the appropriate
port and try it…..
Thanks
good luck
Oki C3200 message on screen says '171 Fatal
Yes it can be saved, it is indicating the fuser thermister is open or below temperature. Try opening the printer and restarting it. If that does not fix it you may have to replace the thermister or the fuser
Replaced K toner and machine is telling me there
There are sensors along the inside right wall that tell the unit if there is a K cartridge inserted. Usually what happens is that due to a toner spill, the sensor LED is covered with toner and or is bad . Hence it does not see the K cartridge. This happens mostly with the black or K cartridge. Get some compressed air and lightly shoot some into the hole that corresponds to the K cardtridge. Only in the hole, do not spray the air anywhere else in the printer.
If this does not clear it up, you would need to replaced the sensor board which is held in with 12 springs!
If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe
I’m happy to assist further over the phone at
https://www.6ya.com/expert/joe_8b8c2cd6ce148309
When I print to my Oki C3200n the paper comes out
The "fuser" uses heat to "bake" the ink onto the paper.
Your printer seems to have a mechanical problem while "feeding" the paper from the "input" tray, through the printer, passing the fuser, and to the "output" tray.
Check that all the rollers that "pull" the paper into the printer are working -- if one of them is not grabbing the paper, the paper "slews".
If you need help, take the printer to a qualified technician for repairs.
380 paper jam
Pull out the toner&drums and see if its under there
Error message OKIC3200n printer
I called the OKI help number, in the manual, and they told me that the second line of the error message, was just an additional reminder, to replace the magenta toner.
EPSON PX700W
I would take them out and double check for any remaining packing material etc and then make sure they are fully inserted. The simple things are always the ones to start with
Not finding what you are looking for?