Rangemaster 110 (Gas) Kitchen Range - Answered Questions & Fixed issues
I have a rangemaster 110 and one of the rings is playing up. It lights and then after a few seconds pops and blows itself out. Even when it is lit and running, after 10 secs or so it does it again. I
Hello,
it is always terrible when items does not work as it should.
I expect that this cooker has flame safety.
The first thing I suspect, is your FFD (=flam failure device). Besides the burner are 2 points, one is for the spark, the other is the sensor for the safety device. On that point is connected a thin copper "wire" that goes to the tap. There it is screwed in.
The test is, stays the burner on when you keep the button pressed in. If that is the case, and the burner goes out after letting go the button, then I am sure it is the FFD.
I hope this helps, Kin regards, Dik
Stop gas burner on rangemaster from cutting out
Try removing the burners and soaking in hot soapy water. If this doesnt work, an old trick is to burn the dirt out. Put the burner in the oven and bake it. The heat will soften any dirt and then washing the burner in hot soapy water usually removes the build up. Try poking a needle into the holes to clear them.
How to fix problems with hob not staying alight on rangemaster lpg
If you are holding the knob in for a good few seconds and finding that it still goes out, the thermocouple has failed on that hob. The thermocouple is the metal spike sticking up when you take the ceramic plate and carrier off each ring. First check that the ring pieces are correctly sitting on the cooker, but if they are you will need that thermocouple replacing.
Flame keeps going out on ring
clean all of the holes the flames come ut f with a small brush t culd be clogged also lift range hod and look under it by the lines see that nothing is loose or obstructing the gas line
Rangemaster 110 no ignition power to oven
Most likely is that some muck is shorting the electrodes in the oven, or underneath. Give the over a good vacuuming both inside and under
/ around the back.
Failing that you'll need to isolate from mains before testing any wiring.
Heating poorly
You need your burner replacing, order on line, just goole your oven model, you will need your serial number, half price of buying from your gas fitter, mine was, it's a five minute job to fit for a gas safe plumber
Not finding what you are looking for?